cdrecord a k3b nevypaluje ani nemaze

Mam takovej problem. Chtel jsem si rozchodit vypalovani a hned jsem narazil. Vzal jsem cd-rw a k3b sama chyba. Tak jsem zkusil cdrecord a taky nevypali ani nesmaze. CD jsem zkousel minimalne dve (vzdy rw - jiny ted nemam). Nevite nekdo, co s tim? O pripadne dalsi info si reknete...

Neuspesne mazani:

$cdrecord -v blank=all /dev/hdb

wodim: No write mode specified.
wodim: Asuming -tao mode.
wodim: Future versions of wodim may have different drive dependent defaults.
TOC Type: 1 = CD-ROM
Device was not specified. Trying to find an appropriate drive...
Detected CD-R drive: /dev/cdrw
Using /dev/cdrom of unknown capabilities
scsidev: '/dev/cdrom'
devname: '/dev/cdrom'
scsibus: -2 target: -2 lun: -2
Linux sg driver version: 3.5.27
Wodim version: 1.1.6
Driveropts: 'burnfree'
SCSI buffer size: 64512
Device type    : Removable CD-ROM
Version        : 0
Response Format: 2
Capabilities   :
Vendor_info    : 'Slimtype'
Identification : 'DVDRW SOSW-852S '
Revision       : 'PRS9'
Device seems to be: Generic mmc2 DVD-R/DVD-RW.
Current: 0x000A (CD-RW)
Profile: 0x002B (DVD+R/DL)
Profile: 0x001B (DVD+R)
Profile: 0x001A (DVD+RW)
Profile: 0x0014 (DVD-RW sequential recording)
Profile: 0x0013 (DVD-RW restricted overwrite)
Profile: 0x0011 (DVD-R sequential recording)
Profile: 0x0010 (DVD-ROM)
Profile: 0x000A (CD-RW) (current)
Profile: 0x0009 (CD-R)
Profile: 0x0008 (CD-ROM)
wodim: Warning: controller returns wrong page 3 for Ricoh Vendor Page page (30).
Using generic SCSI-3/mmc   CD-R/CD-RW driver (mmc_cdr).
Driver flags   : MMC-3 SWABAUDIO BURNFREE
Supported modes: TAO PACKET SAO SAO/R96P SAO/R96R RAW/R16 RAW/R96P RAW/R96R
Drive buf size : 1422080 = 1388 KB
Beginning DMA speed test. Set CDR_NODMATEST environment variable if device
communication breaks or freezes immediately after that.
FIFO size      : 12582912 = 12288 KB
Track 01: data  unknown length
Total size:        0 MB (00:00.00) = 0 sectors
Lout start:        0 MB (00:02/00) = 0 sectors
Current Secsize: 2048
ATIP info from disk:
  Indicated writing power: 6
  Reference speed: 2
  Is not unrestricted
  Is erasable
  ATIP start of lead in:  -11078 (97:34/22)
  ATIP start of lead out: 359849 (79:59/74)
  1T speed low:  0 (reserved val  0) 1T speed high:  4
  2T speed low:  0 (reserved val  5) 2T speed high:  0 (reserved val 12)
  power mult factor: 3 5
  recommended erase/write power: 3
  A1 values: 02 3A B0
  A2 values: 5C C6 26
Disk type:    Phase change
Manuf. index: 11
Manufacturer: Mitsubishi Chemical Corporation
wodim: WARNING: Total disk size unknown. Data may not fit on disk.
wodim: Warning: controller returns wrong page 3 for Ricoh Vendor Page page (30).
Speed set to 706 KB/s
Starting to write CD/DVD at speed   4.0 in real TAO mode for single session.
Last chance to quit, starting real write i   0 seconds. Operation starts.
Waiting for reader process to fill input buffer ... input buffer ready.
Performing OPC...
Blanking entire disk
Errno: 0 (Success), blank unit scsi sendcmd: no error
CDB:  A1 00 00 00 00 00 00 00 00 00 00 00
status: 0x2 (CHECK CONDITION)
Sense Bytes: 70 00 03 00 00 00 00 0A 00 00 00 00 51 00 00 00
Sense Key: 0x3 Medium Error, Segment 0
Sense Code: 0x51 Qual 0x00 (erase failure) Fru 0x0
Sense flags: Blk 0 (not valid)
cmd finished after 55.589s timeout 9600s
wodim: Cannot blank disk, aborting.
Writing  time:   55.684s
wodim: Warning: controller returns wrong page 3 for Ricoh Vendor Page page (30).
wodim: fifo had 1 puts and 0 gets.
wodim: fifo was 0 times empty and 0 times full, min fill was 100%.

Jinak cdrecord je link na wodim a ma prava:

-rws--x--x 1 root root 357632 2007-07-08 17:26 /usr/bin/wodim

Jeste verze:

$ wodim --version
Cdrecord-yelling-line-to-tell-frontends-to-use-it-like-version 2.01.01a03-dvd
Wodim 1.1.6
Copyright (C) 2006 Cdrkit suite contributors
Based on works from Joerg Schilling, Copyright (C) 1995-2006, J. Schilling

Distro Gentoo. Jsem ve skupine cdrom i cdrw.

brw-rw---- 1 root cdrom 3, 64 2007-09-26 15:06 /dev/hdb
lrwxrwxrwx 1 root root 3 2007-09-26 15:06 /dev/cdrom -> hdb
lrwxrwxrwx 1 root root 3 2007-09-26 15:06 /dev/cdrw -> hdb

Pouzivane cd-rw jsem (na jinem pocitaci - jeste to zkusim na tomhle a dam vedet) ve windows bez problemu smazal. Zadne dalsi info me uz nenapada.

jestli jsem správně trefil typ mechaniky, tak tady se kolem ní něco řeší a je tam pár odkazů.

nejdřív bych zkusil ji použít v jiném počítači, případně pod win a pak šlehnout firmware, třeba to pomůže

27.9.2007 18:21 Leshy | skóre: 4
Rozbalit Rozbalit vše Re: cdrecord a k3b nevypaluje ani nemaze

No tak jsme zkusil par firmware a ve win jsem zjistil, ze to nejede. No a protoze to nejelo ani kdyz jsem vratil firmware puvodni, tak soudim, ze to nejelo ani predtim ve win. Treba Nero(win) se sice tvari, ze vypalilo uspesne, ale na cd ve skutecnosti nic neni - teda fyzicky je, ale vypada to jako by palil nekde odprostred na prazdne medium, takze se pak nic nenacte.

No ale dvd-rw vypaluje k3b v pohode, takze tech par iso souboru si holt vypalim nekde jinde, nebo je zkusim vypalit na nomalni cd a ne cd-rw, ktere ted bohuzel zadne po ruce nemam. Nebo zapatram jestli existuje neco, co mi udela z cd isa dvd iso (kdyby nekdo vedel...).

27.9.2007 18:40 pic | skóre: 30 | blog: Perdido_Street_Station
Rozbalit Rozbalit vše Re: cdrecord a k3b nevypaluje ani nemaze

tak to bych zkusil další krok - reklamaci

28.9.2007 00:32 Leshy | skóre: 4
Rozbalit Rozbalit vše Re: cdrecord a k3b nevypaluje ani nemaze

Nj, na to uz je pozde. Ale jak jsem psal, tak palim vlastne sem tam iso s nejakou distribuci pro nekoho jinyho. Chtel jsem to zprovoznit jen pri prilezitosti a navic paleni dvd (a mozna i cd-r) funguje. Jinak tu mam kolem sebe takovou malou sit, kde ma kazdy taky vypalovacku, takze neni problem si to vypalit jinde - jen me zajimalo proc to nejde.

Jo a dik vsem za rady.

Dotaz: cdrecord a k3b nevypaluje ani nemaze

Odpovědi