Dobrý den.
Stáhnul jsem si LiveCd Saxanu. Vše jsem nastavil a připravil na kompilaci. Použivám genkernel, po spuštění skriptu se vše zastaví:
genkernel all
* Gentoo Linux Genkernel; Version 3.4.10
* Running with options: all
* Linux Kernel 2.6.25-gentoo-r4 for x86...
* kernel: >> Running mrproper...
* config: Using config from /etc/kernels/kernel-config-x86-2.6.25-gentoo-r4
* Previous config backed up to .config.bak
* >> Running oldconfig...
* kernel: >> Cleaning...
* >> Compiling 2.6.25-gentoo-r4 bzImage...
* >> Compiling 2.6.25-gentoo-r4 modules...
* Copying config for successful build to /etc/kernels/kernel-config-x86-2.6.25-gentoo-r4
* busybox: >> Using cache
* initramfs: >> Initializing...
* >> Appending base_layout cpio data...
* >> Appending auxilary cpio data...
* >> Appending busybox cpio data...
* >> Appending modules cpio data...
*
* Kernel compiled successfully!
*
* Required Kernel Parameters:
* real_root=/dev/$ROOT
*
* Where $ROOT is the device node for your root partition as the
* one specified in /etc/fstab
*
* If you require Genkernel's hardware detection features; you MUST
* tell your bootloader to use the provided INITRAMFS file. Otherwise;
* substitute the root argument for the real_root argument if you are
* not planning to use the initrd...
* WARNING... WARNING... WARNING...
* Additional kernel cmdline arguments that *may* be required to boot properly...
Zkoušel jsem hledat a nic moc. Děkuji za odpověď.
Ahoj , tak v prvé řadě potřebuješ mít funkční připojení na net, po instalaci na disk. Pokud máš, tak potřebuješ stáhnout aktuální kernel, rozbalit třeba v "mc" a nakopírovat do adresáře "/usr/src/.....".Dále je třeba nastavit příkazem "ln -snf linux-2.6.25...... linux" symbolický odkaz. Tady najdeš víc: kernel-upgrade .Pak musíš zaktualizovat portage takto :
"emerge sync" no a nakonec můžeš použít příkaz "genkernel all". Taky nezapomeň nastavit grub. Je toho ještě víc, jestli máš zájem, nebo budeš potřebovat další pomoc, tak dej nějaký kontakt na sebe. zdar
..Zítra je taky den, ale nebylo by špatné už dnes něco řešit ....
Zdrojaky jadra uz urcite ma pretoze hore bol vypis genkernelu po kompilacii.Uz to treba iba zapisat do grubu..a ten link nebude musiet robit iba v pripade ze pouzil USE="symlink"