Administrace komentářů

ns syslog-ng # dmesg
Linux version 2.6.9-gentoo-r1 (root@livecd) (gcc version 3.3.4 20040623 
(Gentoo Linux 3.3.4-r1, ssp-3.3.2-2, pie-8.7.6)) 
#1 SMP Mon Jun 6 17:31:41 Local time zone must be set--see zic m
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009f800 (usable)
 BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000eac00 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000007ff0000 (usable)
 BIOS-e820: 0000000007ff0000 - 0000000007fffc00 (ACPI data)
 BIOS-e820: 0000000007fffc00 - 0000000008000000 (ACPI NVS)
 BIOS-e820: 00000000fffeac00 - 0000000100000000 (reserved)
127MB LOWMEM available.
On node 0 totalpages: 32752
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 28656 pages, LIFO batch:6
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.2 present.
ACPI: RSDP (v000 HP                                    ) @ 0x000f68e0
ACPI: RSDT (v001 HP     HPCCD HX 0x00010000 TFSM 0x00010010) @ 0x07ffd750
ACPI: FADT (v001 HP     HPCCD HX 0x00010000 MSFT 0x00010010) @ 0x07fffb65
ACPI: BOOT (v001 PTLTD  $SBFTBL$ 0x00000000  LTP 0x00000001) @ 0x07fffbd9
ACPI: DSDT (v001     HP HPCCD HX 0x00010000 MSFT 0x0100000a) @ 0x00000000
Built 1 zonelists
Kernel command line: root=/dev/hda3 vga=792
No local APIC present or hardware disabled
Initializing CPU#0
CPU 0 irqstacks, hard=c060a000 soft=c0602000
PID hash table entries: 512 (order: 9, 8192 bytes)
Detected 400.903 MHz processor.
Using tsc for high-res timesource
Console: colour VGA+ 80x25
Dentry cache hash table entries: 32768 (order: 5, 131072 bytes)
Inode-cache hash table entries: 16384 (order: 4, 65536 bytes)
Memory: 123572k/131008k available (3714k kernel code, 6924k reserved, 1150k data, 236k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 786.43 BogoMIPS (lpj=393216)
Mount-cache hash table entries: 512 (order: 0, 4096 bytes)
CPU: After generic identify, caps: 0183f9ff 00000000 00000000 00000000
CPU: After vendor identify, caps:  0183f9ff 00000000 00000000 00000000
CPU: L1 I cache: 16K, L1 D cache: 16K
CPU: L2 cache: 128K
CPU: After all inits, caps:        0183f9ff 00000000 00000000 00000040
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
Enabling fast FPU save and restore... done.
Checking 'hlt' instruction... OK.
ACPI: IRQ9 SCI: Level Trigger.
CPU0: Intel Celeron (Mendocino) stepping 05
per-CPU timeslice cutoff: 366.06 usecs.
task migration cache decay timeout: 1 msecs.
SMP motherboard not detected.
Local APIC not detected. Using dummy APIC emulation.
Brought up 1 CPUs
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfd9d6, last bus=1
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20040816
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (00:00)
PCI: Probing PCI hardware (bus 00)
PCI: Ignoring BAR0-3 of IDE controller 0000:00:00.1
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 3 *9 10 12)
ACPI: PCI Interrupt Link [LNKB] (IRQs 3 9 10 12) *0, disabled.
ACPI: PCI Interrupt Link [LNKC] (IRQs *3 9 10 12)
ACPI: PCI Interrupt Link [LNKD] (IRQs 3 9 *10 12)
ACPI: PCI Interrupt Link [LNKE] (IRQs *11)
Linux Plug and Play Support v0.97 (c) Adam Belay
SCSI subsystem initialized
usbcore: registered new driver usbfs
usbcore: registered new driver hub
PCI: Using ACPI for IRQ routing
ACPI: PCI Interrupt Link [LNKA] enabled at IRQ 9
ACPI: PCI interrupt 0000:00:00.1[A] -> GSI 9 (level, low) -> IRQ 9
ACPI: PCI Interrupt Link [LNKE] enabled at IRQ 11
ACPI: PCI interrupt 0000:00:01.2[A] -> GSI 11 (level, low) -> IRQ 11
ACPI: PCI Interrupt Link [LNKD] enabled at IRQ 10
ACPI: PCI interrupt 0000:00:06.0[A] -> GSI 10 (level, low) -> IRQ 10
ACPI: PCI Interrupt Link [LNKC] enabled at IRQ 3
ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 3 (level, low) -> IRQ 3
ACPI: PCI interrupt 0000:01:00.0[A] -> GSI 9 (level, low) -> IRQ 9
Simple Boot Flag at 0x36 set to 0x1
Machine check exception polling timer started.
audit: initializing netlink socket (disabled)
audit(1119038604.4294965584:0): initialized
devfs: 2004-01-31 Richard Gooch (rgooch@atnf.csiro.au)
devfs: boot_options: 0x1
Installing knfsd (copyright (C) 1996 okir@monad.swb.de).
SGI XFS with large block numbers, no debug enabled
inotify init: minor=63
lp: driver loaded but no devices found
Linux agpgart interface v0.100 (c) Dave Jones
sisfb: Options vesafb: Silicon Integrated Systems Corp., 6306, 0A (OEM: SiS)
vesafb: VBE version: 2.0
vesafb: protected mode interface info at c785:0000
vesafb: pmi: set display start = c00c78a5, set palette = c00c7919
vesafb: monitor limits: vf = 0 Hz, hf = 0 kHz, clk = 0 MHz
vesafb: scrolling: redraw
Console: switching to colour frame buffer device 128x48
vesafb: framebuffer at 0xf7000000, mapped to 0xc8880000, size 4096k
fb0: VESA VGA frame buffer device
ACPI: Power Button (FF) [PWRF]
ACPI: Processor [CPU0] (supports C1, 8 throttling states)
serio: i8042 KBD port at 0x60,0x64 irq 1
Serial: 8250/16550 driver $Revision: 1.90 $ 8 ports, IRQ sharing disabled
mice: PS/2 mouse device common for all mice
input: AT Translated Set 2 keyboard on isa0060/serio0
Using anticipatory io scheduler
Floppy drive(s): fd0 is 1.44M
FDC 0 is a post-1991 82077
8139too Fast Ethernet driver 0.9.27
ACPI: PCI interrupt 0000:00:0a.0[A] -> GSI 3 (level, low) -> IRQ 3
eth0: RealTek RTL8139 at 0xd800, 4c:00:10:60:78:20, IRQ 3
eth0:  Identified 8139 chip type 'RTL-8100B/8139D'
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
Probing IDE interface ide0...
hda: WDC WD100BB-00AUA1, ATA DISK drive
Probing IDE interface ide1...
hdc: SONY CD-RW CRX230ED, ATAPI CD/DVD-ROM drive
Probing IDE interface ide2...
ide2: Wait for ready failed before probe !
Probing IDE interface ide3...
ide3: Wait for ready failed before probe !
Probing IDE interface ide4...
ide4: Wait for ready failed before probe !
Probing IDE interface ide5...
ide5: Wait for ready failed before probe !
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 128KiB
hda: 19541088 sectors (10005 MB) w/2048KiB Cache, CHS=19386/16/63
hda: cache flushes not supported
 /dev/ide/host0/bus0/target0/lun0: p1 p2 p3 p4
hdc: ATAPI 52X CD-ROM CD-R/RW drive, 2048kB Cache
Uniform CD-ROM driver Revision: 3.20
libata version 1.02 loaded.
ieee1394: raw1394: /dev/raw1394 device initialized
USB Universal Host Controller Interface driver v2.2
usbcore: registered new driver usblp
drivers/usb/class/usblp.c: v0.13: USB Printer Device Class driver
Initializing USB Mass Storage driver...
usbcore: registered new driver usb-storage
USB Mass Storage support registered.
usbcore: registered new driver usbhid
drivers/usb/input/hid-core.c: v2.0:USB HID core driver
Advanced Linux Sound Architecture Driver Version 1.0.6 (Sun Aug 15 07:17:53 2004 UTC).
ALSA device list:
  No soundcards found.
oprofile: using timer interrupt.
NET: Registered protocol family 2
IP: routing cache hash table of 512 buckets, 4Kbytes
TCP: Hash tables configured (established 8192 bind 8192)
ip_conntrack version 2.1 (1023 buckets, 8184 max) - 304 bytes per conntrack
ip_tables: (C) 2000-2002 Netfilter core team
ipt_recent v0.3.1: Stephen Frost http://snowman.net/projects/ipt_recent/
arp_tables: (C) 2002 David S. Miller
NET: Registered protocol family 1
NET: Registered protocol family 17
ACPI: (supports S0 S1 S4 S5)
ACPI wakeup devices:
LNKE PS2K USB0
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
kjournald starting.  Commit interval 5 seconds
Mounted devfs on /dev
Freeing unused kernel memory: 236k freed
Adding 248996k swap on /dev/hda2.  Priority:-1 extents:1
EXT3 FS on hda3, internal journal
EXT3 FS on hda4, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
eth0: link up, 100Mbps, full-duplex, lpa 0x45E1
process `named' is using obsolete setsockopt SO_BSDCOMPAT
spurious 8259A interrupt: IRQ7.
process `dig' is using obsolete setsockopt SO_BSDCOMPAT
ns syslog-ng #