Adaptec 39160

viz. napr. http://www.adaptec.com/products/guide/ultra160scsi.html
-funguje jak s 64bit PCI tak s 32bit PCI.
- 2 SCSI kanaly

Adaptec AIC7xxx driver version: 5.1.30/3.2.4
Compile Options:
TCQ Enabled By Default : Disabled
AIC7XXX_PROC_STATS : Enabled
AIC7XXX_RESET_DELAY : 6

Adapter Configuration:
SCSI Adapter: Adaptec AIC-7899 Ultra 160/m SCSI host adapter
Ultra-160/m LVD/SE Wide Controller Channel A at PCI 2
/4/0
PCI MMAPed I/O Base: 0xf4200000
Adapter SEEPROM Config: SEEPROM found and used.
Adaptec SCSI BIOS: Disabled
IRQ: 5
SCBs: Active 0, Max Active 1,
Allocated 15, HW 32, Page 255
Interrupts: 7508873
BIOS Control Word: 0xa0f8
Adapter Control Word: 0x3c59
Extended Translation: Enabled
Disconnect Enable Flags: 0xffff
Ultra Enable Flags: 0x0000
...
...

Zcela bezproblemove. Pokud pouzivame moduly, v conf.modules
by melo byt : alias scsi_hostadapter aic7xxx - pokud z SCSI na tomto
radici bootujeme, je treba mit zajistene natazeni ovladace pres initrd
(man mkinitrd). Pokud nechceme pouzit initrd, je treba dat ovladac napevno
do jadra (CONFIG_SCSI_AIC7XXX=y).

Velice hezka vecicka. Pouzivam jej v desce
Intel L440GX+ (2xPIII CPU)spolu s jejim internim SCSI Adaptecem,
takze mam k dispozici 4 kanaly. Na serveru je softwarovy
RAID1 a RAID5. Pri prvotni instalaci je treba nejdrive vyradit BIOS interniho
Adaptecu, jinak se deska pochopitelne vubec nerozbehne