EDIMAX EW-7317UHG

[1222249.203039] usb 1-3: new high speed USB device using ehci_hcd and address 9
[1222249.341436] usb 1-3: configuration #1 chosen from 1 choice
[1222249.520039] usb 1-3: reset high speed USB device using ehci_hcd and address 9
[1222249.650030] phy2: Selected rate control algorithm 'minstrel'
[1222249.651291] zd1211rw 1-3:1.0: phy2
[1222249.651326] usbcore: registered new interface driver zd1211rw
[1222250.072704] udev: renamed network interface wlan1 to wlan2
[1222250.073966] usb 1-3: firmware: requesting zd1211/zd1211b_ub
[1222250.237681] usb 1-3: firmware: requesting zd1211/zd1211b_uphr
[1222250.302530] zd1211rw 1-3:1.0: firmware version 4725
[1222250.342529] zd1211rw 1-3:1.0: zd1211b chip 0ace:1215 v4810 high 00-0e-2e AL2230_RF pa0 ----S
[1222250.345301] cfg80211: Calling CRDA for country: DE
[1222250.367331] ADDRCONF(NETDEV_UP): wlan2: link is not ready
[1222250.420969] cfg80211: Current regulatory domain intersected: 
[1222250.420975] 	(start_freq - end_freq @ bandwidth), (max_antenna_gain, max_eirp)
[1222250.420979] 	(2402000 KHz - 2472000 KHz @ 40000 KHz), (N/A, 2000 mBm)
[1222250.420983] 	(2457000 KHz - 2472000 KHz @ 15000 KHz), (N/A, 2000 mBm)
[1222250.420986] 	(5170000 KHz - 5250000 KHz @ 40000 KHz), (N/A, 1700 mBm)
[1222250.529056] wlan2: Selected IBSS BSSID 06:57:3f:29:35:a4 based on configured SSID
[1222260.648016] wlan2: no IPv6 routers present

Bus 001 Device 009: ID 0ace:1215 ZyDAS ZD1211B 802.11g