SafeWay LAN adapter PCMCIA

PCMCIA sitovka 10/100Mb chip Realtek

---

test

kernel: Linux Kernel Card Services 3.1.22 kernel: options: [pci] [cardbus] [pm] kernel: PCI: Found IRQ 10 for device 00:04.0 kernel: PCI: Found IRQ 10 for device 00:04.1 kernel: PCI: Sharing IRQ 10 with 01:00.1 kernel: Yenta IRQ list 08d8, PCI irq10 kernel: Socket status: 30000006 kernel: Yenta IRQ list 08d8, PCI irq10 kernel: Socket status: 30000020 kernel: cs: cb_alloc(bus 6): vendor 0x10ec, device 0x8139 kernel: PCI: Enabling device 06:00.0 (0000 -> 0003) kernel: cs: IO port probe 0x0c00-0x0cff: clean. kernel: cs: IO port probe 0x0100-0x04ff: excluding 0x120-0x127 0x220-0x22f 0x378-0x37f 0x388-0x38f 0x4d0-0x4d7 kernel: cs: IO port probe 0x0a00-0x0aff: clean. kernel: 8139cp 10/100 PCI Ethernet driver v0.0.7 (Feb 27, 2002) kernel: 8139cp: pci dev 06:00.0 (id 10ec:8139 rev 10) is not an 8139C+ compatible chip kernel: 8139cp: Try the "8139too" driver instead.

po insmod

kernel: 8139too Fast Ethernet driver 0.9.24 kernel: PCI: Setting latency timer of device 06:00.0 to 64 kernel: eth0: RealTek RTL8139 Fast Ethernet at 0xca888000, 00:02:44:5b:6d:35, IRQ 10 /etc/hotplug/net.agent: invoke ifup eth0 kernel: eth0: Setting 100mbps full-duplex based on auto-negotiated partner ability 41e1.

---

test

Dodam jen ze ovladac je i na vyrobcem dodane diskete. Pod RH73 s povolenym PCMCIA (tedy Yenta socket a nainstalovane kernel-pcmcia-cs-3.1.27-18 kde je cardmgr se karta po nabootovani v poradku ohlasi jen Yenta socket ji detekuje jako 8139cp coz je spatne nicmene doporuci pouzit module 8319too, ktery je tim spravnym. Pak uz staci jen spustit treba kudzu a nastavit parametry site.

Strucne:
reboot (neni nutne)
kudzu (neni nutne)
insmod mii
insmod 8139too

Pripadne do /etc/modules.conf pridejte
alias eth0 8139too

Jeste bych doporucil prehodit inicializace site (network) v prislusnem /etc/rcX.d za inicializaci PCMCIA.

Sitovka je ready, zadna magie

---

test

za 1100,- udela dobrou sluzbu

---

test