Linksys WPC54G

• Wireless G notebook adapter
• CardBus 32bit PCMCIA
• WiFi 2.4GHz 802.11b/g
• BroadCom BCM4318
• WEP, WPA, WPA2 (rev 3.1)
• nema konektor pro pripojeni externi anteny

$ dmesg
pcmcia_socket pcmcia_socket1: pccard: CardBus card inserted into slot 1
pci 0000:07:00.0: reg 10 32bit mmio: [0x000000-0x001fff]
b43-pci-bridge 0000:07:00.0: enabling device (0000 -> 0002)
b43-pci-bridge 0000:07:00.0: PCI INT A -> Link[LNKB] -> GSI 10 (level, low) -> IRQ 10
b43-pci-bridge 0000:07:00.0: setting latency timer to 64
ssb: Sonics Silicon Backplane found on PCI device 0000:07:00.0
b43-phy1: Broadcom 4318 WLAN found
wmaster1 (b43): not using net_device_ops yet
phy1: Selected rate control algorithm 'minstrel'
wlan1 (b43): not using net_device_ops yet
Broadcom 43xx driver loaded [ Features: PLR, Firmware-ID: FW13 ]
input: b43-phy1 as /class/input/input10
b43 ssb0:0: firmware: requesting b43/ucode5.fw
b43 ssb0:0: firmware: requesting b43/pcm5.fw
b43 ssb0:0: firmware: requesting b43/b0g0initvals5.fw
b43 ssb0:0: firmware: requesting b43/b0g0bsinitvals5.fw
b43-phy1: Loading firmware version 410.2160 (2007-05-26 15:32:10)
Registered led device: b43-phy1::tx
Registered led device: b43-phy1::rx
Registered led device: b43-phy1::radio
b43-phy1: Radio turned on by software
ADDRCONF(NETDEV_UP): wlan1: link is not ready

$ lspci
02:00.0 Network controller: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)

$ lsmod
Module                  Size  Used by
b43                   120200  0

Device drivers
  --> Network device support
    --> Wireless LAN
      [*] Wireless LAN (IEEE 802.11)
      <M> Broadcom 43xx wireless support (mac80211 stack)
        [*]   Broadcom 43xx PCMCIA device support

Postup by mel byt platny pro kernel 2.6.24+:

Stahnout firmware z linuxwireless.org a ten umistit do '/lib/firmware/'.

# modprobe b43

Melo by dojit k vytvoreni rozhrani wmasterX a wlanX.

Doporucuji vzdy postupovat dle dokumentace primo na strankach ovladace.