Fujitsu Siemens C1020

P4 mobile Celeron 1.8GHz (256 KB cache)
VIA twister-P4 (P4N266/VT8233)
256MB DDR SO DIMM (max. 2ks 512MB)
S3 ProSavage8 (shared 8/16/32 MB RAM)
LAN Realtech RTL8139C 10/100Mb
HDD FUJITSU MHS2020AT E (20GB)
DVD drive QSI DVD-ROM SDR-083 (8/20X)
Floppy drive
15" LCD
audio/modem Conexant Cx20468 (SW modem)
Porty:
2xPCMCIA,2xUSB,COM,LPT,IrDA1.1,FireWire,S-Video,VGA,LAN, modem,SPDIFout(optika),mikrofon,sluchatka
!!chyba ps/2 na mys a klavesnicu (treba USB)

lspci:
00:00.0 Host bridge: VIA Technologies, Inc. P4M266 Host Bridge
00:01.0 PCI bridge: VIA Technologies, Inc. VT8633 [Apollo Pro266 AGP]
00:0a.0 CardBus bridge: O2 Micro, Inc. OZ6933 Cardbus Controller (rev 01)
00:0a.1 CardBus bridge: O2 Micro, Inc. OZ6933 Cardbus Controller (rev 01)
00:0c.0 FireWire (IEEE 1394): Texas Instruments TSB43AB21 IEEE-1394 Controller (PHY/Link) 1394a-2000
00:0d.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL-8139/8139C (rev 10)
00:11.0 ISA bridge: VIA Technologies, Inc. VT8233 PCI to ISA Bridge
00:11.1 IDE interface: VIA Technologies, Inc. Bus Master IDE (rev 06)
00:11.2 USB Controller: VIA Technologies, Inc. USB (rev 23)
00:11.3 USB Controller: VIA Technologies, Inc. USB (rev 23)
00:11.4 USB Controller: VIA Technologies, Inc. USB (rev 23)
00:11.5 Multimedia audio controller: VIA Technologies, Inc. VT8233 AC97 Audio Controller (rev 30)
00:11.6 Communication controller: VIA Technologies, Inc. AC97 Modem Controller (rev 70)
01:00.0 VGA compatible controller: S3 Inc. VT8751 [ProSavageDDR P4M266] VGA Controller

cat /proc/ide/via
----------VIA BusMastering IDE Configuration----------------
Driver Version:                     3.34
South Bridge:                       VIA vt8233

Revision:                           ISA 0x0 IDE 0x6
Highest DMA rate:                   UDMA100
BM-DMA base:                        0x1100
PCI clock:                          33.3MHz
Master Read  Cycle IRDY:            0ws
Master Write Cycle IRDY:            0ws
BM IDE Status Register Read Retry:  yes
Max DRDY Pulse Width:               No limit
-----------------------Primary IDE-------Secondary IDE------
Read DMA FIFO flush:          yes                 yes
End Sector FIFO flush:         no                  no
Prefetch Buffer:               no                  no
Post Write Buffer:            yes                 yes
Enabled:                      yes                 yes
Simplex only:                  no                  no
Cable Type:                   80w                 40w
-------------------drive0----drive1----drive2----drive3-----
Transfer Mode:       UDMA       PIO      UDMA       PIO
Address Setup:       30ns     120ns      30ns     120ns
Cmd Active:          90ns      90ns      90ns      90ns
Cmd Recovery:        30ns      30ns      30ns      30ns
Data Active:         90ns     330ns      90ns     330ns
Data Recovery:       30ns     270ns      30ns     270ns
Cycle Time:          20ns     600ns      60ns     600ns
Transfer Rate:   99.9MB/s   3.3MB/s  33.3MB/s   3.3MB/s

Mandrake 9.0 bezproblemov
Mandrake 9.1 - pri instalacii v parametroch boot managera sa da zapnut ACPI.

---

Muj popis funkcnosti jednotlivych casti notebooku pod Linuxem jsou na strance http://www.fi.muni.cz/~kas/c1020/.

Da sa menit konfiguracia (hdd 10,20,40GB memory 128MB-1GB ..)
nejde apm, stale hlasi ze ide na siet. Bude treba vyskusat ACPI
conexant modem nejde, nasiel som nejake drivery od vyrobcu ale zatial som neskusal.
Som prekvapeny - mplayer po prelozeni na prehrava filmy bez akychkolvek problemov
procesor na cca 30%, interne reproduktory hraju znesitelne.
-------dodatok
Ak zaheslujete BIOS a povolite HDD Security bude zaheslovany aj pristup na HDD
Ak zabudenete heslo alebo premazete BIOS HDD je nefunkcny - pokial HDD nedostane
od BIOSu heslo neodpoveda na poziadavky o prenos dat (ani ked ho premiestnite do PC)
Ma to 2 dosledky:
1. mate chranene udaje aj ked ukradnu notebook, pripadny zlodej musi dokupit disk. Co potesi.
2. ked zabudnete heslo mate po datach. Da sa v Nemecku napalit novy Bios disku
po prevereni ci ste majitelom notebooku. Ale doprava+cena=novy disk. Co nepotesi.
Plati aj pre Linux pretoze zaheslovanie sa deje na urovni BIOSov disku+pocitaca.
Plati pre 2,5" Fujitsu HDD + FSC BIOS (aj pre desktop MB). Otestovane na zakaznikovi
ktory zabudol heslo do BIOSu
-------dodatok
V Mandrake 9.1 funguje ACPI - vidno stav baterie, daju sa predefinovat akcie
pri stlaceni power tlacitka a zavreti notebooku.