HP ProLiant ML350

Podpora:	kompletní
Ovladač:	v jádře

Technické parametry

2x Intel Xeon 2.8 GHz
2 GB RAM
HP SmartArray 641 SCSI RAID
sitovka Broadcom

Identifikace pod Linuxem

lspci:

00:00.0 Host bridge: ServerWorks CNB20-HE Host Bridge (rev 32)
00:00.1 Host bridge: ServerWorks CNB20-HE Host Bridge
00:00.2 Host bridge: ServerWorks CNB20-HE Host Bridge
00:02.0 SCSI storage controller: Adaptec AHA-3960D / AIC-7899A U160/m (rev 01)
00:02.1 SCSI storage controller: Adaptec AHA-3960D / AIC-7899A U160/m (rev 01)
00:03.0 VGA compatible controller: ATI Technologies Inc Rage XL (rev 27)
00:04.0 Ethernet controller: Broadcom Corporation NetXtreme BCM5702 Gigabit Ethernet (rev 02)
00:05.0 System peripheral: Compaq Computer Corporation Advanced System Management Controller
00:0f.0 ISA bridge: ServerWorks CSB5 South Bridge (rev 93)
00:0f.1 IDE interface: ServerWorks CSB5 IDE Controller (rev 93)
00:0f.2 USB Controller: ServerWorks OSB4/CSB5 OHCI USB Controller (rev 05)
00:0f.3 Host bridge: ServerWorks GCLE Host Bridge
00:11.0 Host bridge: ServerWorks: Unknown device 0101 (rev 05)
00:11.2 Host bridge: ServerWorks: Unknown device 0101 (rev 05)
02:01.0 RAID bus controller: Compaq Computer Corporation Smart Array 64xx (rev 01)

Postup zprovoznění pod Linuxem

- v BIOSu jsem nastavil OS type Linux.
- nainstaloval jsem Linux(v mem pripade FC 1). Instalace a dalsi pouzivani zatim bez problemu.

RAID radic pracuje s modulem cciss.o, sitova karta s modulem tg3.o a obycejny SCSI radic s aic7xxx.o

U verze G4, neni mozne ve SmartTools zvolit Linux. Proto jsem nastroje pouzil pouze pro konfiguraci disku. V momente, kdy to chtelo zvolit OS, jsem vybral Novell Netware, vytvoril minimalni oddil s FAT a nechal zapsat, restartoval a nainstaloval linux (slackware 10.2). zapsat partition je nutne, protoze bez toho fdisk neotevre zarizeni /dev/cciss/c0d0.

Poznámka

Ventilator pri startu desne huci.