Portál AbcLinuxu, 13. prosince 2025 12:39
| Ovladač: | v jádře |
Umí to SmartMediaTM Card, Type I/II CompactFlashTM Card, MultiMediaTM Card, IBM MicrodriveTM , Secure DigitalTM Card a Memory Stick.
Více info + fotka u výrobce: http://apacer.com/apacer_english/product_html/mega_steno11.asp
Při připojení:
kernel: hub 1-0:1.0: new USB device on port 2, assigned address 5 kernel: SCSI subsystem initialized kernel: Initializing USB Mass Storage driver... kernel: scsi0 : SCSI emulation for USB Mass Storage devices kernel: Vendor: Apacer Model: Mega Steno Rev: 1.03 kernel: Type: Direct-Access ANSI SCSI revision: 02 scsi.agent[2557]: how to add device type= at /devices/pci0000:00/0000:00:11.2/usb1/1-2/1-2:1.0/host0/0:0:0:0 ?? kernel: Vendor: Apacer Model: Mega Steno Rev: 1.03 kernel: Type: Direct-Access ANSI SCSI revision: 02 scsi.agent[2572]: how to add device type= at /devices/pci0000:00/0000:00:11.2/usb1/1-2/1-2:1.0/host0/0:0:0:1 ?? kernel: Vendor: Apacer Model: Mega Steno Rev: 1.03 kernel: Type: Direct-Access ANSI SCSI revision: 02 kernel: WARNING: USB Mass Storage data integrity not assured kernel: USB Mass Storage device found at 5 kernel: drivers/usb/core/usb.c: registered new driver usb-storage kernel: USB Mass Storage support registered. scsi.agent[2587]: disk at /devices/pci0000:00/0000:00:11.2/usb1/1-2/1-2:1.0/host0/0:0:0:2 kernel: Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 kernel: Attached scsi removable disk sdb at scsi0, channel 0, id 0, lun 1 kernel: Attached scsi removable disk sdc at scsi0, channel 0, id 0, lun 2
Mountu s 8MB CompactFlash a mountu s 512MB CompactFlash:
kernel: SCSI device sda: 15680 512-byte hdwr sectors (8 MB) kernel: sda: Write Protect is off kernel: SCSI device sda: 15680 512-byte hdwr sectors (8 MB) kernel: sda: Write Protect is off kernel: sda: sda1 kernel: SCSI device sda: 1043968 512-byte hdwr sectors (535 MB) kernel: sda: Write Protect is off kernel: SCSI device sda: 1043968 512-byte hdwr sectors (535 MB) kernel: sda: Write Protect is off kernel: sda: sda1
Výstuplsusb:
Bus 001 Device 005: ID 0d7d:0240 Apacer I/O Magic Drive
Device Descriptor:
bLength 18
bDescriptorType 1
bcdUSB 1.10
bDeviceClass 0 (Defined at Interface level)
bDeviceSubClass 0
bDeviceProtocol 0
bMaxPacketSize0 8
idVendor 0x0d7d Apacer
idProduct 0x0240 I/O Magic Drive
bcdDevice 1.00
iManufacturer 1 Apacer
iProduct 2 Mega Steno
iSerial 3 19220DA1018B
bNumConfigurations 1
Configuration Descriptor:
bLength 9
bDescriptorType 2
wTotalLength 39
bNumInterfaces 1
bConfigurationValue 1
iConfiguration 0
bmAttributes 0x80
MaxPower 350mA
Interface Descriptor:
bLength 9
bDescriptorType 4
bInterfaceNumber 0
bAlternateSetting 0
bNumEndpoints 3
bInterfaceClass 8 Mass Storage
bInterfaceSubClass 6 SCSI
bInterfaceProtocol 80 Bulk (Zip)
iInterface 0
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x81 EP 1 IN
bmAttributes 2
Transfer Type Bulk
Synch Type none
wMaxPacketSize 64
bInterval 255
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x02 EP 2 OUT
bmAttributes 2
Transfer Type Bulk
Synch Type none
wMaxPacketSize 64
bInterval 255
Endpoint Descriptor:
bLength 7
bDescriptorType 5
bEndpointAddress 0x83 EP 3 IN
bmAttributes 3
Transfer Type Interrupt
Synch Type none
wMaxPacketSize 2
bInterval 1
Language IDs: (length=4)
0409 English(US)
Pokud je již rozběhané usb, tak stačí připojit, měl by se natáhnout modul usb-storage.
Kernel by měl být zkompilován s následujícími volbami:
CONFIG_USB_STORAGE CONFIG_SCSI CONFIG_SCSI_MULTI_LUN (jinak je vidět jen jeden disk místo tří) CONFIG_BLK_DEV_SD
Po výměně média je potřeba 2x pustit mount, poprvý to nikdy neprojde (platí jen pro 2.4, pod 2.6 kernely už naprosto v pohodě).
Testováno na kernelu 2.4.20 a 2.6.0-test9 a jen s několika Compact Flash Type I kartami.
Dokument vytvořil: Michal Čihař, 23.4.2003 21:39 | Zobrazeno: 916×
Tiskni
Sdílej:
ISSN 1214-1267, (c) 1999-2007 Stickfish s.r.o.