Portál AbcLinuxu, 29. října 2025 22:25
smartctl 6.5 2016-05-07 r4318 [x86_64-linux-4.14.70-desktop-2.mga6] (local build)
Copyright (C) 2002-16, Bruce Allen, Christian Franke, www.smartmontools.org
=== START OF INFORMATION SECTION ===
Device Model: ADATA SU700
Serial Number: 2H2420081743
LU WWN Device Id: 5 707c18 10051fbdb
Firmware Version: B170206b
User Capacity: 240,057,409,536 bytes [240 GB]
Sector Size: 512 bytes logical/physical
Rotation Rate: Solid State Device
Form Factor: 2.5 inches
Device is: Not in smartctl database [for details use: -P showall]
ATA Version is: ACS-2 (minor revision not indicated)
SATA Version is: SATA 3.2, 6.0 Gb/s (current: 1.5 Gb/s)
Local Time is: Tue Oct 23 09:15:14 2018 CEST
SMART support is: Available - device has SMART capability.
SMART support is: Enabled
=== START OF READ SMART DATA SECTION ===
SMART overall-health self-assessment test result: PASSED
General SMART Values:
Offline data collection status: (0x00) Offline data collection activity
was never started.
Auto Offline Data Collection: Disabled.
Self-test execution status: ( 0) The previous self-test routine completed
without error or no self-test has ever
been run.
Total time to complete Offline
data collection: ( 33) seconds.
Offline data collection
capabilities: (0x7b) SMART execute Offline immediate.
Auto Offline data collection on/off support.
Suspend Offline collection upon new
command.
Offline surface scan supported.
Self-test supported.
Conveyance Self-test supported.
Selective Self-test supported.
SMART capabilities: (0x0003) Saves SMART data before entering
power-saving mode.
Supports SMART auto save timer.
Error logging capability: (0x01) Error logging supported.
General Purpose Logging supported.
Short self-test routine
recommended polling time: ( 1) minutes.
Extended self-test routine
recommended polling time: ( 1) minutes.
Conveyance self-test routine
recommended polling time: ( 1) minutes.
SCT capabilities: (0x0039) SCT Status supported.
SCT Error Recovery Control supported.
SCT Feature Control supported.
SCT Data Table supported.
SMART Attributes Data Structure revision number: 0
Vendor Specific SMART Attributes with Thresholds:
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE
9 Power_On_Hours 0x0012 100 100 000 Old_age Always - 2193
12 Power_Cycle_Count 0x0012 100 100 000 Old_age Always - 619
167 Unknown_Attribute 0x0022 100 100 000 Old_age Always - 0
168 Unknown_Attribute 0x0012 100 100 000 Old_age Always - 0
169 Unknown_Attribute 0x0013 099 099 010 Pre-fail Always - 65542
173 Unknown_Attribute 0x0012 200 200 000 Old_age Always - 4296605705
175 Program_Fail_Count_Chip 0x0013 060 100 010 Pre-fail Always - 0
180 Unused_Rsvd_Blk_Cnt_Tot 0x0033 100 100 020 Pre-fail Always - 911
192 Power-Off_Retract_Count 0x0012 100 100 000 Old_age Always - 0
194 Temperature_Celsius 0x0022 068 068 030 Old_age Always - 32 (Min/Max 32/40)
231 Temperature_Celsius 0x0033 100 100 005 Pre-fail Always - 0
233 Media_Wearout_Indicator 0x0032 100 100 000 Old_age Always - 6929788032
234 Unknown_Attribute 0x0032 100 100 000 Old_age Always - 1905396056064
241 Total_LBAs_Written 0x0032 100 100 000 Old_age Always - 4487839635
242 Total_LBAs_Read 0x0032 100 100 000 Old_age Always - 4203644125
SMART Error Log Version: 1
Warning: ATA error count 65535 inconsistent with error log pointer 2
ATA Error Count: 65535 (device log contains only the most recent five errors)
CR = Command Register [HEX]
FR = Features Register [HEX]
SC = Sector Count Register [HEX]
SN = Sector Number Register [HEX]
CL = Cylinder Low Register [HEX]
CH = Cylinder High Register [HEX]
DH = Device/Head Register [HEX]
DC = Device Command Register [HEX]
ER = Error register [HEX]
ST = Status register [HEX]
Powered_Up_Time is measured from power on, and printed as
DDd+hh:mm:SS.sss where DD=days, hh=hours, mm=minutes,
SS=sec, and sss=millisec. It "wraps" after 49.710 days.
Error 65535 occurred at disk power-on lifetime: 2193 hours (91 days + 9 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 80 00 19 33 e2 Error: UNC 128 sectors at LBA = 0x02331900 = 36903168
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 00 5d 34 e2 08 01:42:14.600 READ DMA
ef 10 02 00 00 00 a0 08 01:42:14.600 SET FEATURES [Enable SATA feature]
00 00 00 00 00 00 a0 08 01:42:14.600 NOP [Abort queued commands]
ec 00 00 00 00 00 a0 08 01:42:14.600 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 08 01:42:14.600 SET FEATURES [Set transfer mode]
Error 65534 occurred at disk power-on lifetime: 2193 hours (91 days + 9 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 80 f8 18 33 e2 Error: UNC 128 sectors at LBA = 0x023318f8 = 36903160
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 00 5d 34 e2 08 01:42:14.200 READ DMA
ef 10 02 00 00 00 a0 08 01:42:14.200 SET FEATURES [Enable SATA feature]
00 00 00 00 00 00 a0 08 01:42:14.200 NOP [Abort queued commands]
ec 00 00 00 00 00 a0 08 01:42:14.200 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 08 01:42:14.200 SET FEATURES [Set transfer mode]
Error 65533 occurred at disk power-on lifetime: 2193 hours (91 days + 9 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 80 00 fe 32 e2 Error: UNC 128 sectors at LBA = 0x0232fe00 = 36896256
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 00 5d 34 e2 08 01:42:13.900 READ DMA
ef 10 02 00 00 00 a0 08 01:42:13.900 SET FEATURES [Enable SATA feature]
00 00 00 00 00 00 a0 08 01:42:13.900 NOP [Abort queued commands]
ec 00 00 00 00 00 a0 08 01:42:13.900 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 08 01:42:13.900 SET FEATURES [Set transfer mode]
Error 65532 occurred at disk power-on lifetime: 2193 hours (91 days + 9 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 80 f8 fd 32 e2 Error: UNC 128 sectors at LBA = 0x0232fdf8 = 36896248
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 00 5d 34 e2 08 01:42:13.500 READ DMA
ef 10 02 00 00 00 a0 08 01:42:13.500 SET FEATURES [Enable SATA feature]
00 00 00 00 00 00 a0 08 01:42:13.500 NOP [Abort queued commands]
ec 00 00 00 00 00 a0 08 01:42:13.500 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 08 01:42:13.500 SET FEATURES [Set transfer mode]
Error 65531 occurred at disk power-on lifetime: 2193 hours (91 days + 9 hours)
When the command that caused the error occurred, the device was active or idle.
After command completion occurred, registers were:
ER ST SC SN CL CH DH
-- -- -- -- -- -- --
40 51 80 00 da 32 e2 Error: UNC 128 sectors at LBA = 0x0232da00 = 36887040
Commands leading to the command that caused the error were:
CR FR SC SN CL CH DH DC Powered_Up_Time Command/Feature_Name
-- -- -- -- -- -- -- -- ---------------- --------------------
c8 00 80 00 5d 34 e2 08 01:42:13.100 READ DMA
ef 10 02 00 00 00 a0 08 01:42:13.100 SET FEATURES [Enable SATA feature]
00 00 00 00 00 00 a0 08 01:42:13.100 NOP [Abort queued commands]
ec 00 00 00 00 00 a0 08 01:42:13.100 IDENTIFY DEVICE
ef 03 42 00 00 00 a0 08 01:42:13.100 SET FEATURES [Set transfer mode]
SMART Self-test log structure revision number 1
Num Test_Description Status Remaining LifeTime(hours) LBA_of_first_error
# 1 Short offline Completed without error 00% 1794 -
# 2 Short offline Completed without error 00% 1794 -
# 3 Short offline Completed without error 00% 1794 -
# 4 Short offline Completed without error 00% 1794 -
SMART Selective self-test log data structure revision number 1
SPAN MIN_LBA MAX_LBA CURRENT_TEST_STATUS
1 0 0 Not_testing
2 0 0 Not_testing
3 0 0 Not_testing
4 0 0 Not_testing
5 0 0 Not_testing
Selective self-test flags (0x0):
After scanning selected spans, do NOT read-scan remainder of disk.
If Selective self-test is pending on power-up, resume after 0 minute delay.
23.10.2018 11:14
Pavel 'TIGER' Růžička | skóre: 54
echo $((4487839635*512/1024/1024/1024)) = 2139GB ~= 2TB
24.10.2018 02:55
Jendа | skóre: 78
| blog: Jenda
| JO70FB
Model Family: SandForce Driven SSDs Device Model: KINGSTON SV300S37A480G ... 241 Lifetime_Writes_GiB 0x0032 000 000 000 Old_age Always - 37 242 Lifetime_Reads_GiB 0x0032 000 000 000 Old_age Always - 19(disk mám tři roky jako jediný v desktopu, takže tam budou protočeny terabajty, ne 37 GB)
Tiskni
Sdílej:
ISSN 1214-1267, (c) 1999-2007 Stickfish s.r.o.