Dotaz: LILO: EBDA is big

[Johny]

Zdravim diskuzi, potrebuju za pomoci lila nabootovat jadro velikosti 2 MB z usb disku. Pri bootu dostanu hlasku

"EBDA is big, kernel setup stack overlaps LILO 2nd stage".

Kdyz pouziju parametr "linear" (-l) tak instalator oznami

"Sector adress too large for linear".

Co mam kde prenastavit, v configu kernelu ani lila jsem nic nenasel. Verze lila a kernelu zrejme nerozhoduji. Dik za pripadne konstruktivni napady :)

Odpovědi

[Martinn]

Mel jsem stejny problem: nebylo spravne zapsane lilo, stacilo spustit lilo s parametrem v (lilo -v) a ono si uz reklo co ma za problem a jak to resit (u me pridanim dalsiho parametru - jaky to byl parametr uz si bohuzel nevzpominam).

[asd]

from lilo README. lilo-22.7.1 Build-time configuration - - - - - - - - - - - -

Certain build-time parameters can be configured. They can either be edited in the top-level Makefile or they can be stored in a file /etc/lilo.defines. Settings in the Makefile are ignored if that file exists.

The following items can be configured: ... LARGE_EDBA Loads LILO at a lower address in order to leave more space for the EBDA (Extended BIOS Data Area). This is necessary on some recent MP systems. Note that enabling LARGE_EDBA reduces the maximum size of "small" images (e.g. "Image" or "zImage"). ...

[asd]

./Makefile:# LARGE_EBDA Deprecated since Oct-2000 (version 21.6).

z kodu to taky vypada odstranene. ted jen otazka cim to nahradili...

[Johny]

Tak jsem to nakonec vyresil pouzitim jineho zavadece :]