Portál AbcLinuxu, 12. listopadu 2025 08:34
ifdown wlan0
wlan0 device: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
wlan0 configuration: wlan-wlan0
SuSEfirewall2: Warning: ip6tables does not support state matching. Extended IPv6 support disabled.
SuSEfirewall2: Setting up rules from /etc/sysconfig/SuSEfirewall2 ...
SuSEfirewall2: batch committing...
SuSEfirewall2: Firewall rules successfully set
iwconfig
wlan0 IEEE 802.11b ESSID:"tully" Nickname:"tulyNX6125"
Mode:Managed Frequency:2.417 GHz Access Point: 00:E0:98:C5:AE:44
Bit Rate=11 Mb/s Tx-Power:25 dBm
RTS thr:off Fragment thr:off
Encryption key:7475-6C6C-79 Security mode:restricted
Power Management:off
Link Quality:100/100 Signal level:-50 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:61491 Missed beacon:0
rmmod -f ndiswrapper
tulyNX6125:/home/towdie # iwconfig
lo no wireless extensions.
eth0 no wireless extensions.
wlan0 IEEE 802.11g ESSID:off/any
Mode:Managed Frequency:2.462 GHz Access Point: 00:00:00:00:00:00
Bit Rate=54 Mb/s Tx-Power:25 dBm
RTS thr:off Fragment thr:off
Encryption key:off
Power Management:off
Link Quality:0 Signal level:0 Noise level:0
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0
prosim o radu (google nepomohol :( )
ifconfig wlan0 down nefunguje?
Tiskni
Sdílej:
ISSN 1214-1267, (c) 1999-2007 Stickfish s.r.o.