Dotaz: Vlloženi příkazů

[Pengiun]

Tsch"uss. Mám problém s miší, který prý mohu vyřešit, tak že zadám kod. viz Zde . Není mi jasno, kam se ten kod vklada. Zkoušel jsem to dat do konzole, ale vrátilo mi to "command not found".

Předem děkují

Odpovědi

[Pengiun]

http://www.abclinuxu.cz/forum/show/129209

Click Here

[kozzi]

no a co stoho nevis jakej prikaz tam je konfigurace Xek napis presne prikaz kterej zkousis zadavat

[Pengiun]

Mám Mandrake. Nevím přesně v čem jsem chyboval.

Section "InputDevice"
  Identifier  "Configured Mouse"
  Driver      "mouse"
  Option      "Protocol" "ExplorerPS/2"
  Option      "Device" "/dev/input/mice"
  Option      "Buttons" "7"
  Option      "ZAxisMapping" "6 7"
EndSectio



[penguin@prenatal penguin]$ InputDevice
bash: InputDevice: command not found
[penguin@prenatal penguin]$

[kozzi]

no treba v tom ze to nejsou prikazy ale cast souboru /etc/X11/xorg.conf zde musis najit polozku tykajici se mysi a nahradit tim co jsi tu psal

[Pengiun]

tak mi napiš tak, jak to má bejt, prosím. Fakt nemám potuchu, co ty různý věci znamenají. Potřebuju příklad. Dík

[kozzi]

no proste si jako root otevri soubor /etc/X11/xorg.conf no ten projet a najdi tam neco ve stulu

Section "InputDevice"

# Identifier and driver

    Identifier	"Mouse1"
    Driver	"mouse"
    Option "Protocol"    "IMPS/2"	# IntelliMouse PS/2
    Option "Device"      "/dev/input/mouse0"

# When using XQUEUE, comment out the above two lines, and uncomment
# the following line.

#    Option "Protocol"	"Xqueue"

# Mouse-speed setting for PS/2 mouse.

#    Option "Resolution"	"256"

# Baudrate and SampleRate are only for some Logitech mice. In
# almost every case these lines should be omitted.

#    Option "BaudRate"	"9600"
#    Option "SampleRate"	"150"

# Mouse wheel mapping.  Default is to map vertical wheel to buttons 4 & 5,
# horizontal wheel to buttons 6 & 7.   Change if your mouse has more than
# 3 buttons and you need to map the wheel to different button ids to avoid
# conflicts.

    Option "ZAxisMapping"   "4 5 6 7"

# Emulate3Buttons is an option for 2-button mice
# Emulate3Timeout is the timeout in milliseconds (default is 50ms)

    Option "Emulate3Buttons"
#    Option "Emulate3Timeout"    "50"

# ChordMiddle is an option for some 3-button Logitech mice

#    Option "ChordMiddle"

EndSection

proste cas tykajici se mysi a tam to uprav podle toho cos psal vyse asi nejak takto

Section "InputDevice"
 Identifier "Configured Mouse"
 Driver "mouse"
 Option "CorePointer"
 Option "Device" "/dev/input/mice"
 Option "Protocol" "ExplorerPS/2"
 Option "Emulate3Buttons" "true"
 Option "Buttons" "7"
 Option "ZAxisMapping" "6 7"
EndSection

no a potom to co psali dal

[vladimir]

tak se trochu snaz, lamo