PDA HP 1940 a linux

Zdravím,mám mandrivu a výše uvedené pda, po připojení přes usb se mi hlásí:

usb 2-2: new full speed USB device using uhci_hcd and address 2

usb 2-2: configuration #1 chosen from 1 choice

SCSI subsystem initialized

Initializing USB Mass Storage driver...

scsi0 : SCSI emulation for USB Mass Storage devices

usbcore: registered new driver usb-storage

USB Mass Storage support registered.

usb-storage: device found at 2

usb-storage: waiting for device to settle before scanning

usbcore: registered new driver ub

Vendor: DV 3100 Model: Rev: 1.00

Type: Direct-Access ANSI SCSI

revision: 00

usb-storage: device scan complete

SCSI device sda: 61440 512-byte hdwr sectors (31 MB)

sda: test WP failed, assume Write Enabled

sda: assuming drive cache: write through

SCSI device sda: 61440 512-byte hdwr sectors (31 MB)

sda: test WP failed, assume Write Enabled

sda: assuming drive cache: write through

sda: sda1

sd 0:0:0:0: Attached scsi removable disk sda

Buffer I/O error on device sda1, logical block 15680

Buffer I/O error on device sda1, logical block 15681

Buffer I/O error on device sda1, logical block 15680

Buffer I/O error on device sda1, logical block 15681

usb 2-2: USB disconnect, address 2

0:0:0:0: rejecting I/O to dead device

usb 2-2: new full speed USB device using uhci_hcd and address 3

usb 2-2: configuration #1 chosen from 1 choice

drivers/usb/serial/usb-serial.c: USB Serial support registered for PocketPC PDA

drivers/usb/serial/ipaq.c: USB PocketPC PDA driver v0.5

ipaq 2-2:1.0: PocketPC PDA converter detected

usb 2-2: PocketPC PDA converter now attached to ttyUSB0

usbcore: registered new driver ipaq

je možné to nějak přimountovat? v partitions ale žádné sda není, jedná se mi hlavně o možnost stahování a vkládání dat. Nebo je k tomu porřeba nějaký software, můžete mi něco doporučit?

Dotaz: PDA HP 1940 a linux