Dotaz: Routerboard X Mikrotik

[Sirius2]

Uz dobu se peru s Mikrotikem...wifinu pouzivam CM9 a pokousim se pripojit k 5GHz APcku, jenze ono se vubec nedari:( Kdyz dam proskenovani, tak ho to vidi, ale ouhle se to nechce pripojit. Neni tam naka zasadni vec co se musi udelat? Nebo kdyby si nekdo dal chvilku a napsal detailni postup, tak bych byl jeho dluznikem. Dekuji za kazdou dobrou radu.

Odpovědi

[deelite]

Hmm, ja som s tym nemal ziaden problem. Vsetko od nastartovania sietovky som robil cez winbox. Napada ma, nema to APcko zapnuty MAC filter? Teraz som v praci, vecer ti poslem nastavenie mojho mikrotiku.

[deelite]

Tak som sa k tomu konecne dostal
Tu su slubene nastavenia. Obidve radia su na 5G, jedno je AP, druhe klient.

[admin@MikroTik] interface wireless> print
Flags: X - disabled, R - running

0 R name="wlan1" mtu=1500 mac-address=00:0B:6B:4D:FB:E7 arp=enabled disable-running-check=no interface-type=Atheros AR5213 radio-name="000B6B4DFBE7" mode=station ssid="MOJESSID" area="" frequency-mode=manual-txpower country=slovak republic antenna-gain=0 frequency=5540 band=5ghz scan-list=default rate-set=default supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps, 54Mbps basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007 ack-timeout=51 tx-power=17 tx-power-mode=all-rates-fixed noise-floor-threshold=default periodic-calibration=default periodic-calibration-interval=60 burst-time=disabled dfs-mode=none antenna-mode=ant-a wds-mode=disabled wds-default-bridge=none wds-default-cost=100 wds-cost-range=50-150 wds-ignore-ssid=no update-stats-interval=disabled default-authentication=yes default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0 hide-ssid=no security-profile=default disconnect-timeout=3s on-fail-retry-time=100ms preamble-mode=both compression=no allow-sharedkey=no

1 R name="wlan2" mtu=1500 mac-address=00:0B:6B:4D:F8:88 arp=enabled disable-running-check=no interface-type=Atheros AR5213 radio-name="000B6B4DF888" mode=ap-bridge ssid="MOJESSID2" area="" frequency-mode=manual-txpower country=slovak republic antenna-gain=0 frequency=5500 band=5ghz scan-list=default rate-set=default supported-rates-b=1Mbps,2Mbps,5.5Mbps,11Mbps supported-rates-a/g=6Mbps,9Mbps,12Mbps,18Mbps,24Mbps,36Mbps,48Mbps, 54Mbps basic-rates-b=1Mbps basic-rates-a/g=6Mbps max-station-count=2007 ack-timeout=52 tx-power=17 tx-power-mode=all-rates-fixed noise-floor-threshold=default periodic-calibration=default periodic-calibration-interval=60 burst-time=disabled dfs-mode=none antenna-mode=ant-a wds-mode=disabled wds-default-bridge=none wds-default-cost=100 wds-cost-range=50-150 wds-ignore-ssid=no update-stats-interval=disabled default-authentication=yes default-forwarding=yes default-ap-tx-limit=0 default-client-tx-limit=0 hide-ssid=no security-profile=default disconnect-timeout=3s on-fail-retry-time=100ms preamble-mode=both compression=no allow-sharedkey=no

[k3]

zeptej se podpory mikrotiku.. btw: uz k tomu konecne davaj i zdrojaky GPL veci jenz uvnitr pouzivaji ?