bttv po loadnuti huci

ahoj,

funguju na Debianu a driv na nem fungovala i moje tv karta. Po te co jsem presel na 2.6 jadro mi po loadnuti bttv modulu zacne hucet zvuk (takovy ten white-noise jako kdyz neni naladeno).

Zkousel jsem ruzne options pro bttv ale bez uspechu.

(#modprobe bttv tuner=19 card=63 radio=0)

Kdyz mam naloadovany bttv a zapnu tvtime tak zvuk normalne nabehne a po ukonceni uz to nehuci. Mplayer vubec nedetekuje zvuk ale presto se zvuk rozjede a huceni prestane. Bohuzel se vsak zvuk uz nezastavi. ani po skonceni mplayeru.

Zda se ze to pri loadovani bttv neregistruje zadny zvukovi device. Neni to chyba? (vis dmesg)

Mam nainstalovanou ALSU.

Protoze se to autodetektne uz pri bootu tak to zacne hucet o dost driv nez se da s komplem vubec neco delat. Dal sem proto bttv do /etc/hotplug/blacklist ale ignoruje se to.

Nejsim prilis zkuseny linuxak, mozna mi neco unika, ale kdyby jste meli napad co zkusit tak dik moc.

TV karta je bt878 (stara ATI Wonder): lspci:

0000:00:0a.0 Multimedia video controller: Brooktree Corporation Bt878 Video Capture (rev 02)

0000:00:0a.1 Multimedia controller: Brooktree Corporation Bt878 Audio Capture (rev 02)

dmesg:

bttv0: unloading

bttv: driver version 0.9.16 loaded

bttv: using 8 buffers with 2080k (520 pages) each for capture

bttv: Bt8xx card found (0).

bttv0: Bt878 (rev 2) at 0000:00:0a.0, irq: 10, latency: 64, mmio: 0xdbdfe000

bttv0: detected: ATI TV Wonder [card=63], PCI subsystem ID is 1002:0001

bttv0: using: ATI TV-Wonder [card=63,insmod option]

bttv0: gpio: en=00000000, out=00000000 in=00ffffff [init]

bttv0: using tuner=19

bttv0: i2c: checking for MSP34xx @ 0x80... found

bttv0: i2c: checking for TDA9875 @ 0xb0... not found

bttv0: i2c: checking for TDA7432 @ 0x8a... not found

bttv0: i2c: checking for TDA9887 @ 0x86... not found

bttv0: registered device video0

bttv0: registered device vbi0

dik Vlada.

Dotaz: bttv po loadnuti huci

Odpovědi