Portál AbcLinuxu, 13. května 2025 22:12
iwl3945 0000:0c:00.0: PCI INT A -> GSI 17 (level, low) -> IRQ 17 iwl3945 0000:0c:00.0: restoring config space at offset 0x1 (was 0x100102, writing 0x100106) firmware: requesting iwlwifi-3945-1.ucode Registered led device: iwl-phy0:radio Registered led device: iwl-phy0:assoc Registered led device: iwl-phy0:RX Registered led device: iwl-phy0:TX ADDRCONF(NETDEV_UP): wlan0: link is not ready iwl3945: WARNING: Requesting MAC access during RFKILL wakes up NIC iwl3945: MAC is in deep sleep! iwl3945: WARNING: Requesting MAC access during RFKILL wakes up NIC iwl3945: MAC is in deep sleep! iwl3945: WARNING: Requesting MAC access during RFKILL wakes up NIC iwl3945: MAC is in deep sleep! iwl3945: WARNING: Requesting MAC access during RFKILL wakes up NIC iwl3945 0000:0c:00.0: PCI INT A disabled ADDRCONF(NETDEV_UP): eth0: link is not ready tg3: eth0: Link is up at 100 Mbps, full duplex. tg3: eth0: Flow control is on for TX and on for RX. ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready eth0: no IPv6 routers presentCelé mi to přijde že je ten modul je nastaven tak že když není připojení k AP tak se vypne, ale nikde to nastavení nemůžu najít. Zkoušel jsem hledat tady i na gentoo wiki a nic.
Na otázku zatím nikdo bohužel neodpověděl.
Tiskni
Sdílej:
ISSN 1214-1267, (c) 1999-2007 Stickfish s.r.o.