mod AP s XG-901 v jadre 2.6.26-1-686

Nazdarek,

Potreboval bych poradit. Mam debian a v nem Zcom XG-901, v jadre 2.6.18 fungovala s driverem prism54, ted kdyz jsem nainstalovat 2.6.26-1-686 driver prism54 zmizel. Nasel jsem na netu ze se to zmenilo na p54pci. Zkompiloval jsme to stahl firmware lmac_2.7.0.0.arm a 2.7.0.0.arm, ale at uz jsem zkousel ten nebo onen fw karta porad nefunguje. Nelze nastavovat parametry wifi pomoci iwconfig

v dmesg po loadnuti p54pci je:

[ 4346.774759] ACPI: PCI Interrupt 0000:02:08.0[A] -> Link [LNKC] -> GSI 16 (level, low) -> IRQ 16
[ 4346.824491] firmware: requesting isl3886
[ 4346.832695] p54: LM86 firmware
[ 4346.832713] p54: FW rev 2.7.0.0 - Softmac protocol 4.1
[ 4347.675713] p54: unknown eeprom code : 0x1
[ 4347.675732] p54: unknown eeprom code : 0x1007
[ 4347.675744] p54: unknown eeprom code : 0x1008
[ 4347.675756] p54: unknown eeprom code : 0x1100
[ 4347.675768] p54: unknown eeprom code : 0x3
[ 4347.675780] p54: unknown eeprom code : 0x1905
[ 4347.678637] phy2: Selected rate control algorithm 'pid'
[ 4347.679995] phy2: hwaddr 00:60:b3:1c:2d:92, isl3890

pro zadani iwconfig wlan0 mode master essid net channel 1

pise:

Error for wireless request "Set Mode" (8B06) :
SET failed on device wlan0 ; Invalid argument.

vypis lspci:

02:08.0 Network controller: Intersil Corporation ISL3890 [Prism GT/Prism Duette]/ISL3886 [Prism Ja
velin/Prism Xbow] (rev 01)

prosim poradte, potrebuju aby mi to fungovalo v AP modu :) Dekujiiiiiii

Dotaz: mod AP s XG-901 v jadre 2.6.26-1-686