Portál AbcLinuxu, 7. května 2025 22:10
iwconfigwlan0 IEEE 802.11bg ESSID:off/any
Mode:Managed Access Point: Not-Associated Tx-Power=off
Retry long limit:7 RTS thr:off Fragment thr:off
Power Management:off
lo no wireless extensions.
eth0 no wireless extensions.
iwlist scanwlan0 Failed to read scan data : Network is down lo Interface doesn't support scanning. eth0 Interface doesn't support scanning.nieco z vypisov
Řešení dotazu:
sudo ip link set wlan0 up [sudo] password for johncenawwe: RTNETLINK answers: Operation not possible due to RF-kill
rfkill list all0: phy0: Wireless LAN Soft blocked: no Hard blocked: yesskusam aj WICD ale nemozem zapnut WIFI tl.na klavesnici,pri starte mi blikne modra pod tl. ale nejde zapnut ani cez terminal
blacklist hp_wmido souboru
/etc/modprobe.d/hp.confaby se nenatahoval ten ovladac, ted koukam ze se spravne jmenuje hp-wmi a na hp_wmi je odkaz jen v aliasech, kazdopadne muzes pridat blacklist radek radeji i pro hp-wmi, pak restartovat a overit ze to nemas natazene:
lsmod | grep -e hp_wmi -e hp-wmi
20.1.2017 08:37
Pavel 'TIGER' Růžička | skóre: 54
20.1.2017 08:58
Pavel 'TIGER' Růžička | skóre: 54
20.1.2017 08:58
Pavel 'TIGER' Růžička | skóre: 54
sudo rfkill unblock all [sudo] password for johncenawwe: johncenawwe@johncenawwe-HP-Compaq-nx6325-EY352EA-AKR:~$ rfkill list 0: phy0: Wireless LAN Soft blocked: no Hard blocked: yes
cat /etc/modprobe.d/hp.confproste dokud po restartu budes mit natahle hp_wmi tak ho nemas blokovane, takze az ti
lsmod | grep -e hp_wmi -e hp-wminezobrazi nic, tak teprve mas blokovanej modul hp_wmi a prijde na radu:
sudo rfkill unblock alljako nerucim(e) ze to je ono, ale zavrhnout to jen proto ze se ti nedari(?) bloknout modul je moc brzo :)
sudo ifconfig wlan0 up [sudo] password for johncenawwe: SIOCSIFFLAGS: Operace není možná kvůli zakázanému rádiu (RF-kill)
20.1.2017 08:20
Pavel 'TIGER' Růžička | skóre: 54
0: phy0: Wireless LAN Soft blocked: no Hard blocked: yeshosi tu bude pes zakopany,ale ani za toho oneho neviem ako to spojazdnit a ten HADR blocked dat na NO,uz som precital kvantum toho ale neviem co stym poradte ako to spojazdnit prosim
sudo ip link set wlan0 up RTNETLINK answers: Operation not possible due to RF-kill
20.1.2017 18:26
Pavel 'TIGER' Růžička | skóre: 54
johncenawwe@johncenawwe-HP-Compaq-nx6325-EY352EA-AKR:~$ sudo rmmod b43 johncenawwe@johncenawwe-HP-Compaq-nx6325-EY352EA-AKR:~$ sudo modprobe b43 johncenawwe@johncenawwe-HP-Compaq-nx6325-EY352EA-AKR:~$ sudo rfkill list 1: phy1: Wireless LAN Soft blocked: no Hard blocked: yes
lsmod | grep wmiJestli tam je WiFi od Broadcomu a zavedený modul
19.1.2017 23:27
b43, nechybí té kartě jen firmware?
snd_rawmidi 25135 1 snd_seq_midi snd_seq_device 14137 3 snd_seq,snd_rawmidi,snd_seq_midi snd 60871 16 snd_hwdep,snd_timer,snd_pcm,snd_seq,snd_rawmidi,snd_hda_codec,snd_hda_intel,snd_seq_device,snd_hda_codec_analog,snd_seq_midi
# detailni info o pci zarizeni sudo lspci -vnn # o usb zarizeni lsusb -v # a z logu (tak nekdy rozumne brzo po startu/rebootu): dmesg | grep -i -e network -e wifi -e wireless -e firmware -e b43 -e bcm -e network -B1 -A3
30:00.0 Network controller [0280]: Broadcom Limited BCM4311 802.11a/b/g [14e4:4312] (rev 01) Subsystem: Hewlett-Packard Company Broadcom 802.11a/b/g WLAN [103c:1361] Flags: bus master, fast devsel, latency 0, IRQ 18 Memory at c8000000 (32-bit, non-prefetchable) [size=16K] Capabilities: [40] Power Management version 2 Capabilities: [58] MSI: Enable- Count=1/1 Maskable- 64bit- Capabilities: [d0] Express Legacy Endpoint, MSI 00 Capabilities: [100] Advanced Error Reporting Capabilities: [13c] Virtual Channel Kernel driver in use: b43-pci-bridge
dmesg | grep -i -e network -e wifi -e wireless -e firmware -e b43 -e bcm -e network -B1 -A3 [ 0.116485] ACPI: No dock devices found. [ 0.116896] [Firmware Bug]: ACPI: No _BQC method, cannot determine initial brightness [ 0.116920] [Firmware Bug]: ACPI: No _BQC method, cannot determine initial brightness [ 0.120013] ACPI: Power Resource [C22D] (off) [ 0.120934] ACPI: Power Resource [C204] (off) [ 0.121782] ACPI: Power Resource [C221] (on) -- [ 2.816414] tg3.c:v3.134 (Sep 16, 2013) [ 2.891166] tg3 0000:02:01.0 eth0: Tigon3 [partno(BCM95788A50) rev 3003] (PCI:33MHz:32-bit) MAC address 00:17:a4:ce:dd:1f [ 2.891175] tg3 0000:02:01.0 eth0: attached PHY is 5705 (10/100/1000Base-T Ethernet) (WireSpeed[0], EEE[0]) [ 2.891179] tg3 0000:02:01.0 eth0: RXcsums[1] LinkChgREG[0] MIirq[0] ASF[0] TSOcap[1] [ 2.891182] tg3 0000:02:01.0 eth0: dma_rwctrl[763f0000] dma_mask[32-bit] -- [ 25.424209] cfg80211: Calling CRDA to update world regulatory domain [ 25.539168] [Firmware Bug]: _BCQ is used instead of _BQC [ 25.539185] ACPI: Video Device [C07B] (multi-head: yes rom: no post: no) [ 25.539203] [Firmware Bug]: ACPI: No _BQC method, cannot determine initial brightness [ 25.560982] parport_pc 00:01: [io 0x0378-0x037f] [ 25.560993] parport_pc 00:01: [io 0x0778-0x077a] [ 25.561088] parport_pc 00:01: [irq 7] [ 25.561094] parport_pc 00:01: [dma 1] [ 25.562101] b43-phy0: Broadcom 4311 WLAN found (core revision 10) [ 25.583379] acpi device:03: registered as cooling_device5 [ 25.583539] input: Video Bus as /devices/LNXSYSTM:00/device:00/PNP0A03:00/device:01/LNXVIDEO:00/input/input9 [ 25.589025] parport_pc 00:01: activated -- [ 25.589116] parport0: PC-style at 0x378 (0x778), irq 7, dma 1 [PCSPP,TRISTATE,COMPAT,ECP,DMA] [ 25.604066] b43-phy0: Found PHY: Analog 4, Type 2 (G), Revision 8 [ 25.631229] Broadcom 43xx driver loaded [ Features: PNL ] [ 25.654302] wmi: Mapper loaded [ 25.667477] ppdev: user-space parallel port driver -- [ 26.965448] type=1400 audit(1485095037.900:2): apparmor="STATUS" operation="profile_load" profile="unconfined" name="/sbin/dhclient" pid=452 comm="apparmor_parser" [ 26.965462] type=1400 audit(1485095037.900:3): apparmor="STATUS" operation="profile_load" profile="unconfined" name="/usr/lib/NetworkManager/nm-dhcp-client.action" pid=452 comm="apparmor_parser" [ 26.965469] type=1400 audit(1485095037.900:4): apparmor="STATUS" operation="profile_load" profile="unconfined" name="/usr/lib/connman/scripts/dhclient-script" pid=452 comm="apparmor_parser" [ 26.966212] type=1400 audit(1485095037.900:5): apparmor="STATUS" operation="profile_replace" profile="unconfined" name="/usr/lib/NetworkManager/nm-dhcp-client.action" pid=452 comm="apparmor_parser" [ 26.966222] type=1400 audit(1485095037.900:6): apparmor="STATUS" operation="profile_replace" profile="unconfined" name="/usr/lib/connman/scripts/dhclient-script" pid=452 comm="apparmor_parser" [ 26.966593] type=1400 audit(1485095037.900:7): apparmor="STATUS" operation="profile_replace" profile="unconfined" name="/usr/lib/connman/scripts/dhclient-script" pid=452 comm="apparmor_parser" [ 26.994583] type=1400 audit(1485095037.928:8): apparmor="STATUS" operation="profile_load" profile="unconfined" name="/usr/sbin/ntpd" pid=454 comm="apparmor_parser" -- [ 29.270817] input: HDA ATI SB Mic as /devices/pci0000:00/0000:00:14.2/sound/card0/input16 [ 31.872066] b43-phy0: Loading firmware version 666.2 (2011-02-23 01:15:07) [ 31.956384] b43-phy0: Radio hardware status changed to DISABLED [ 31.964042] b43-phy0: Radio turned on by software [ 31.964047] b43-phy0: The hardware RF-kill button still turns the radio physically off. Press the button to turn it on. [ 31.966950] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 32.032915] IPv6: ADDRCONF(NETDEV_UP): wlan0: link is not ready [ 32.514537] init: samba-ad-dc main process (745) terminated with status 1
0: phy0: Wireless LAN Soft blocked: no Hard blocked: no
Tiskni
Sdílej:
ISSN 1214-1267, (c) 1999-2007 Stickfish s.r.o.