Portál AbcLinuxu, 7. listopadu 2025 03:13
2.10.2007 08:28
Dalibor Smolík | skóre: 54
| blog: Postrehy_ze_zivota
| 50°5'31.93"N,14°19'35.51"E
/dev/hda:
ATA device, with non-removable media
Model Number: ST380011A
Serial Number: 5JV936TK
Firmware Revision: 3.06
Standards:
Used: ATA/ATAPI-6 T13 1410D revision 2
Supported: 6 5 4
Configuration:
Logical max current
cylinders 16383 65535
heads 16 1
sectors/track 63 63
--
CHS current addressable sectors: 4128705
LBA user addressable sectors: 156301488
LBA48 user addressable sectors: 156301488
device size with M = 1024*1024: 76319 MBytes
device size with M = 1000*1000: 80026 MBytes (80 GB)
Capabilities:
LBA, IORDY(can be disabled)
Standby timer values: spec'd by Standard
R/W multiple sector transfer: Max = 16 Current = 16
Recommended acoustic management value: 128, current value: 0
DMA: mdma0 mdma1 mdma2 udma0 udma1 udma2 udma3 udma4 *udma5
Cycle time: min=120ns recommended=120ns
PIO: pio0 pio1 pio2 pio3 pio4
Cycle time: no flow control=240ns IORDY flow control=120ns
Commands/features:
Enabled Supported:
* SMART feature set
Security Mode feature set
* Power Management feature set
* Write cache
* Look-ahead
* Host Protected Area feature set
* WRITE_BUFFER command
* READ_BUFFER command
* DOWNLOAD_MICROCODE
SET_MAX security extension
* 48-bit Address feature set
* Device Configuration Overlay feature set
* Mandatory FLUSH_CACHE
* FLUSH_CACHE_EXT
* SMART error logging
* SMART self-test
Security:
supported
not enabled
not locked
not frozen
not expired: security count
not supported: enhanced erase
HW reset results:
CBLID- above Vih
Device num = 0 determined by the jumper
Checksum: correct
Ten stroj jinak zcela normálně funguje. Jakmile se data přestanou zapisovat, začne se chovat normálně - zmiňované 3-sekundové zámrzy ustanou. Myslím si že to bude spíše nějaká neshoda mezi Kernelem a BIOSem/firmwarem disku (alespoň doufám).
ID# ATTRIBUTE_NAME FLAG VALUE WORST THRESH TYPE UPDATED WHEN_FAILED RAW_VALUE 1 Raw_Read_Error_Rate 0x000f 055 051 006 Pre-fail Always - 47851171 3 Spin_Up_Time 0x0003 098 097 000 Pre-fail Always - 0 4 Start_Stop_Count 0x0032 099 099 020 Old_age Always - 1075 5 Reallocated_Sector_Ct 0x0033 100 100 036 Pre-fail Always - 0 7 Seek_Error_Rate 0x000f 086 060 030 Pre-fail Always - 467767084 9 Power_On_Hours 0x0032 090 090 000 Old_age Always - 9510 10 Spin_Retry_Count 0x0013 100 100 097 Pre-fail Always - 0 12 Power_Cycle_Count 0x0032 099 099 020 Old_age Always - 1069 194 Temperature_Celsius 0x0022 037 052 000 Old_age Always - 37 195 Hardware_ECC_Recovered 0x001a 055 050 000 Old_age Always - 47851171 197 Current_Pending_Sector 0x0012 100 100 000 Old_age Always - 0 198 Offline_Uncorrectable 0x0010 100 100 000 Old_age Offline - 0 199 UDMA_CRC_Error_Count 0x003e 200 200 000 Old_age Always - 0 200 Multi_Zone_Error_Rate 0x0000 100 253 000 Old_age Offline - 0 202 TA_Increase_Count 0x0032 100 253 000 Old_age Always - 0Podezřelá mi připadají zvláště neobvykle vysoká čísla Raw_Read_Error_Rate a Seek_Error_Rate, která navíc neustále narůstají... Je toto skutečný signál končící životnosti disku? Nebo může jít o chybu desky či paměti?
name value min max mode ---- ----- --- --- ---- acoustic 0 0 254 rw address 1 0 2 rw bios_cyl 16383 0 65535 rw bios_head 255 0 255 rw bios_sect 63 0 63 rw bswap 0 0 1 r current_speed 0 0 70 rw failures 0 0 65535 rw init_speed 0 0 70 rw io_32bit 0 0 3 rw keepsettings 0 0 1 rw lun 0 0 7 rw max_failures 1 0 65535 rw multcount 16 0 16 rw nice1 1 0 1 rw nowerr 0 0 1 rw number 0 0 3 rw pio_mode write-only 0 255 w unmaskirq 0 0 1 rw using_dma 0 0 1 rw wcache 1 0 1 rwZnamená hodnota 0 u using_dma že DMA je vypnuté? To by totiž mohlo zpomalovat ne?
23.10.2007 15:24
michich | skóre: 51
| blog: ohrivane_parky
23.10.2007 15:33
Luboš Doležel (Doli) | skóre: 98
| blog: Doliho blog
| Kladensko
.
23.10.2007 17:43
Luboš Doležel (Doli) | skóre: 98
| blog: Doliho blog
| Kladensko
Tiskni
Sdílej:
ISSN 1214-1267, (c) 1999-2007 Stickfish s.r.o.