Portál AbcLinuxu, 27. dubna 2024 03:28
0x01 "Illegal command". This shouldn't happen, but if it does, it may indicated an attempt to access a disk which is not supported by the BIOS.
bare.i root=/dev/hdc5 noinitrd ro
), ale to je dost nekomfortni. lilo.conf mi nastavil instalator podle me spravne. jestli to nevyresim, tak se asi poohlidnu po jinym zavadeci, ale stejne bych rad vedel cim to muze byt.
distribuce je slackware 9.1 a zadnej atypickej hw nepouzivam. krom toho je ten pocitac uz starsi, takze novinkovej problem to taky snad neni.
boot = /dev/hdc3 message = /boot/boot_message.txt prompt timeout = 1200 # Override dangerous defaults that rewrite the partition table: change-rules reset # Normal VGA console vga = normal # Linux bootable partition config begins image = /boot/vmlinuz root = /dev/hdc3 label = Linux read-only # Linux bootable partition config endsKdyz zadam lilo tak to zadny chyby nehazi(resp. hlasi Added Linux *). Ale nastartovat to porad nejde. Pritom z CD(bare.i root=/dev/hdc3 noinitrd ro) to jde, takze mapovani na bios-cisla by snad nemelo mit problem. Ach jo...
Tiskni Sdílej:
ISSN 1214-1267, (c) 1999-2007 Stickfish s.r.o.