Administrace komentářů

dmesg:
bcm43xx: Microcode rev 0x127, pl 0xe (2005-04-18  02:36:27)
bcm43xx: Radio turned on
bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopair()
bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopair()
bcm43xx: Chip initialized
bcm43xx: 32-bit DMA initialized
bcm43xx: Keys cleared
bcm43xx: Selected 802.11 core (phytype 2)
bcm43xx: ASSERTION FAILED (radio_attenuation < 10) at: drivers/net/wireless/bcm43xx/bcm43xx_phy.c:1496:bcm43xx_find_lopair()
ADDRCONF(NETDEV_UP): eth1: link is not ready
bcm43xx: set security called, .level = 0, .enabled = 0, .encrypt = 0
SoftMAC: Associate: Scanning for networks first.
SoftMAC: Start scanning with channel: 1
SoftMAC: Scanning 14 channels
SoftMAC: Scanning finished
SoftMAC: Queueing Authentication Request to 00:02:2d:61:a3:56
SoftMAC: Cannot associate without being authenticated, requested authentication
SoftMAC: Sent Authentication Request to 00:02:2d:61:a3:56.
SoftMAC: Sent Authentication Request to 00:02:2d:61:a3:56.
bcm43xx: Radio turned off
bcm43xx: DMA-32 0x0200 (RX) max used slots: 1/64
bcm43xx: DMA-32 0x02A0 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0280 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0260 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0240 (TX) max used slots: 0/512
bcm43xx: DMA-32 0x0220 (TX) max used slots: 2/512
bcm43xx: DMA-32 0x0200 (TX) max used slots: 0/512


[kuba@paladin ~]$ iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

eth1      IEEE 802.11b/g  ESSID:"wlan"  Nickname:"Broadcom 4318"
          Mode:Managed  Frequency=2.412 GHz  Access Point: 00:02:2D:61:A3:56
          Bit Rate=1 Mb/s
          RTS thr:off   Fragment thr:off
          Link Quality=0/100  Signal level=-256 dBm  Noise level=-256 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0