Dotaz: Mandrake a nejde dial-up

[kupakx]

Pisal som na zive.cz,cital prispevky a stale nejde...

btw. som linux. zaciatocnik Mam hardwerovy modem Microcom Deskporte pocket na /dev/modem resp. /dev/ttyS1 Mam Mandrake 10.1, nastavil som pripojenie k netu cez kppp, vsetko automaticky (DNS a pod), Vypnuty oznam. ton (ATX3). Avsak ked dam pripojit (zrobim to zo shellu) kppp: Modem piska ,pripoji sa a asi po 1 min sa vypne spojenie: Mam nastavene tie timeouty na max. hodnoty

Vypis zo shellu (ak je nastaveny v kppp modem na ttyS1.Ked je nastaveny na /dev/modem tak shell nic nevypise.):

[xxxx@localhost xxxx]$ kppp Opener: received SetSecret Opener: received SetSecret Opener: received OpenDevice Opener: received ExecPPPDaemon In parent: pppd pid 4789 Couldn't find interface ppp0: No such device Kernel supports ppp alright. Couldn't find interface ppp0: No such device Couldn't find interface ppp0: No such device Couldn't find interface ppp0: No such device Couldn't find interface ppp0: No such device Couldn't find interface ppp0: No such device Opener: received RemoveSecret Opener: received RemoveSecret Opener: received OpenResolv Opener: received OpenResolv Opener: received KillPPPDaemon In killpppd(): Sending SIGTERM to 4789 It was pppd that died pppd exited with return value 9 Sending 4764 a SIGUSR1 [xxxx@localhost xxxx]$

-Couldn't find interface ppp0: No such device-tych hlasok je velmi vela,preto som to skratil

Ladiace okno pre prihlasovaci skript: ATZ OK ATX3 OK ATM1L1 OK ATX3 OK ATDT01919 CONNECT 115200 V42bis

Poradte co mam nastavit aby to slo. Dakujem za rady

Odpovědi

[Michal Čihař]

1. Nauč se používat <pre></pre>
2. Jseš si jistý, že tvůj provider má telefonní číslo 01919?

[Peter Golis]

2) preco by nemal. je to telefonne cislo pre st dial up analog.
3) nie je treba dat nejake zaznamy do modules.conf aby sa nacital modul jadra pre ppp? napriklad takto?
ps.: ak to nepomohlo, tak treba zadat verziu jadra a obsah /etc/modules.conf

[kupakx]

PPP Logfile:

Feb  7 17:47:21 localhost pppd[6115]: pppd 2.4.2 started by xxxx, uid 501

Feb 7 17:48:21 localhost pppd[6115]: Terminating on signal 15.

Feb  7 17:48:21 localhost pppd[6115]: Exit.

Modules Conf:

# /etc/modules: kernel modules to load at boot time.
#

# This file should contain the names of kernel modules that are

# to be loaded at boot time, one per line.  Comments begin with

# a `#', and everything on the line after them are ignored.

Mam veriu jadra 2.6.8.1 - 12mdksmp (vycitane z /boot/)

Vobec neviem s linuxom pracovat takze nejake nacitat modul ppp do jadra je pre mna spanielska dedina. Dakujem za vysvetlenie.

[robob]

Mam tiez Mdk10.1 a mal som podobne problemy. Modem piskal, vypisal na konci prihlasovania

CONNECT 115200 V42bis

a dalej nic. Vydedukoval som, ze nieco bude pri prihlasovani prilis rychle a nestihne, rsp. necaka na spojenie. Tak som experimentoval a vysledok je, ze mi to uz ide na 100%.

Navod:

1. Spustit kppp

2. Nastavit -> Konta, klik na konto (STOnline u mna), Upravit

3. Prihlasovaci skript, tam vybrat Pause a dopisat hodnotu 1, Pridat

4. OK

Pretoze mi to vypisovalo predtym takmer tie iste hlasky ako Vam je dost pravdepodobne, ze to pomoze. Ja som ale presiel kalvariou kompletnej instalacie modem driveru do jadra + konfigurovanie suborov v /etc atd. (pretoze v udev systeme je to uplne inak ako v devfs ).

Moj modem je D-com s chipsetom Lucent/Agere (winmodem)

[kupakx]

Zrobil som to a ejha, nove hlasky a zase neuspech :(

PPP Skript:

ATZ

OK

ATX3

OK

ATM1L1

OK

ATX3

OK

ATDT01919

CONNECT 115200 V42bis

User Access Verification

Welcome in ISDN ST_OnLine, Enter Your Username:

[xxxx@localhost xxxx]$ kppp

Opener: received SetSecret

Opener: received SetSecret

Opener: received OpenLock

Opener: received OpenDevice

Opener: received ExecPPPDaemon

In parent: pppd pid 5376

Couldn't find interface ppp0: No such device

Kernel supports ppp alright.

Couldn't find interface ppp0: No such device

Opener: received KillPPPDaemon

In killpppd(): Sending SIGTERM to 5376

It was pppd that died

pppd exited with return value 9

Sending 5348 a SIGUSR1

Opener: received RemoveSecret

Opener: received RemoveSecret

Opener: received OpenResolv

Opener: received OpenResolv

Opener: received RemoveLock

Vypise ze mam zadat heslo a neviem kde ho napisat.Po case ma to zhodi. Dal som aj do toho skriptu ID:mojeusername a Password:mojeheslo a aj tak nepomohlo. Dik za radu/y

[robob]

V tomto

Opener: received KillPPPDaemon

zhodi ppp demona, no netusim preco. U mna to nerobi. Zisiel by sa mi vypis lsmod spusteny pod root a tiez vypis dmesg hned po prihlaseni (spusteni) linuxu. A este subor /var/log/ppp/connect-errors. Podla mojho nazoru ale bude najskor chyba v driveri.

Do skriptu nepatri ani ID ani Password.

Heslo a PouzivatelskeID by malo byt zadane hned v prvom dialogu po spusteni kppp. Dufam, ze to mate na 100% spravne. Inak sa objavi vo vypise

It was pppd that died
pppd exited with return value xx

Pozor na zamenu klavesnice Sk/Us! Vyskusajte si Heslo a PouzivatelskeID aj vo Windowse ak ho mate.

[kupakx]

Vo windowse mi net ide..takze meno a heslo je OK. Skusal som tie subory vycitat co ste mi napisali : 1)adresar /smod na mojom pc neni 2)/var/log/ po tade sa dostanem (v KDE 3.2) a potom pise ze priecinok ppp je uzamknuty => neviem vycitat Skusal som aj v shellu prikaz su potom mcedit a otvoril subor /var/log/ppp/connect-errors a tam nic nebolo

Cize ako sa prihlasit v KDE ako root aby mi vsetko otvorilo tj. aj to ppp.

dmesg: subor je na http://kupakx.wz.cz/dmesg.doc

A perlička nakoniec: Ked som dal do shellu su potom heslo roota a dal kppp (spustip kppp) tak ako root mi vypisalo nove hlasky:

obrazok je na http://kupakx.wz.cz (ako pozadie)

Nemyslim si ze by to bola chyba v driveri ked modem komunikuje s pc a pripoji sa do siete a potom vypise Prihlasovaci skript kppp Welcome ST_ISDN... a zaroven shell je bombardovyny hlaskami Couldn´t find interface ...

dik

[robob]

Z toho co som videl mam stale pocit, ze driver nefunguje ako ma. Problem urcite nie je v kppp, to je len frontend nad sluzbami a demonom ppp. To ze komunikuje s PC este naznamena, ze spravne prijima zo siete to co mu ISP modem posle. Mate ICQ?

lsmod je prikaz, ktory vypise zoznam natiahnutych modulov a spusta sa pod root-om.

[kupakx]

Ismod mi v shelli ani nikde inde nesiel :( ICQ nemam resp. uz mam ,na take srandicky nemal som cas ale teraz som si to zrobil moje cislo 246 323 330 .Vobec neviem s tym robit takze neviem ci nieco z toho bude... Inak ak mate cas mozete popisat ako sa pripojit k netu. Robil som to cez grafickeho sprievodcu a nejde to (preto tu pisem...)

[svist]

Doporucoval by som lavy Ctrl+Esc a pozriet ci je po spusteni kppp demon pppd aktivny. Dalej ako root sa pozrite do /var/log/messages a tam by mali byt zaznamy pppd aj s cislom chyby. V konzole napiste man pppd a najdite exit status-y, cize vyznam chybovych kodov. Dalej to nastavenie timeoutu (pause) je dobre zvacsit pre istotu na 3 sekundy.

[kupakx]

Ctrl+Esc - nio ako kpp alebo nieco co sa tyka ppp tam nebolo... Vo /var/log/messages je toho strasne vela nasiel som veci okolo ppp toto:

Feb 7 17:40:18 localhost chat[5552]: abort on (BUSY)

Feb 7 17:40:18 localhost chat[5552]: abort on (ERROR)

Feb 7 17:40:18 localhost chat[5552]: abort on (NO CARRIER)

Feb 7 17:40:18 localhost chat[5552]: abort on (NO DIALTONE)

Feb 7 17:40:18 localhost chat[5552]: abort on (Invalid Login)

Feb 7 17:40:18 localhost chat[5552]: abort on (Login incorrect)

Feb 7 17:40:18 localhost chat[5552]: send (ATZ^M)

Feb 7 17:40:18 localhost chat[5552]: expect (OK)

Feb 7 17:40:19 localhost chat[5552]: ATZ^M^M

Feb 7 17:40:19 localhost chat[5552]: OK

Feb 7 17:40:19 localhost chat[5552]: -- got it

Feb 7 17:40:19 localhost chat[5552]: send (ATDT01919^M)

Feb 7 17:40:19 localhost chat[5552]: expect (CONNECT)

Feb 7 17:40:19 localhost chat[5552]: ^M

Feb 7 17:40:30 localhost chat[5552]: ATDT01919^M^M

Feb 7 17:40:30 localhost chat[5552]: NO DIALTONE

Feb 7 17:40:30 localhost chat[5552]: -- failed

Feb 7 17:40:30 localhost chat[5552]: Failed (NO DIALTONE)

Feb 7 17:40:30 localhost pppd[5533]: Connect script failed

Feb 7 17:40:31 localhost pppd[5533]: Exit.

v PPP logfile mi pise toto:

Feb 12 11:07:39 localhost pppd[5755]: pppd 2.4.2 started by lenin, uid 501

Feb 12 11:08:39 localhost pppd[5755]: Terminating on signal 15.

Feb 12 11:08:39 localhost pppd[5755]: Exit.

v Shelli: .... It was pppd died pppd exited with return value 9.

V man pppd je toto pri hodnote 9: The command specified as the argument to the pty option could not be run

pri: 15 The link was terminated because the peer is not responding to echo requests

Skusil som aj zvysit Pause na 3 a nepomohlo.V tom Ladiacom okne mi stale vypise Welcome ISDN ST_ONline, Enter Your Username: ale neviem kde to zadat! a po case vyskoci okno: Časový limit vypršal pri čakaní na aktiváciu PPP rozhrania!

[Michal Čihař]

Změň vytáčení na ATX3DT01919, pak to nebude čekat na dial tone, kterýho se stejně v našich končinách nedočká.

[kupakx]

Vdaka za prikaz, pomohlo to scasti: V shelli mi uz nevypisuje Couldn´t find... ale par riadkov kde je vsetko v poriadku. Teraz ma uz nechce pripojit lebo pyta meno heslo - a mam ho zadany a ulozeny

kupakx.wz.cz (ako pozadie)

to robob: Vzdy som mal vypnute Cakat na oznam ton, lebo to poznam z Windowsu. Aj to mam nastavene na PAP/CHAP (a to je co?)

[robob]

Skuste v nastaveniach kppp v zalozke modem vypnut Cakat na obsadzovaci ton pred vytacanim. V Konta (STOnline), Upravit, Vytacanie nastavit Overenie: na PAP/CHAP.

P.S. Vsetky Vase vypisy je dobre davat medzi znacky pre. Tie dostanete do textu kliknutim na obdlznik s pre nad editovacim boxom.

[kupakx]

? Poradte...

[jm]

A s cim jako? Chce to uzivatelske jmeno a heslo, tak by ho mozna bylo dobre nekam zadat, z toho nesmyslneho screenshotu pri nejlepsi vuli nevykoukam vubec nic.

[kupakx]

Meno a heslo mam zadane hned v prvom okne kppp. Ked ma to (asi) pripoji na server ST ,tak pyta meno (a heslo), kde ho mam este zadat?