Administrace komentářů

dobry den nema niekto kompletne rozbehanu TV kartu z titulku? mne nejde zvuk ani dialkove ovladanie [to zatial nemusi ;o)]
audio vystup z TV karty mam pripojeny do zvukovky.
skusal som prehravanie v tvtime. obraz, ladenie kanalov je OK. pridavanie hlasitosti reaguje, len zvuk nepocut...
mplayer vypise Audio: no sound tu je cely vystup:

mplayer tv:// -tv driver=v4l2:input=0:norm=PAL:width=768:height=576:channel=U52:brightness=10:contrast=-5:saturation=5:adevice=/dev/dsp
Playing tv://.
TV detected! 
Selected driver: v4l2
 name: Video 4 Linux 2 input
 author: Martin Olschewski <olschewski@zpr.uni-koeln.de>
 comment: first try, more to come 
Selected device: Pinnacle PCTV 110i (saa7133)
 Tuner cap: STEREO LANG1 LANG2
 Tuner rxs: MONO
 Capabilites:  video capture  video overlay  VBI capture device  tuner  read/write  streaming
 supported norms: 0 = PAL; 1 = PAL-BG; 2 = PAL-I; 3 = PAL-DK; 4 = NTSC; 5 = SECAM; 6 = PAL-M; 7 = PAL-Nc; 8 = PAL-60;
 inputs: 0 = Television; 1 = Composite1; 2 = S-Video;
 Current input: 0
 Current format: BGR24
v4l2: current audio mode is : MONO
vo: X11 running at 1280x1024 with depth 24 and 32 bpp (":0.0" => local display)
==========================================================================
Opening video decoder: [raw] RAW Uncompressed Video
VDec: vo config request - 720 x 576 (preferred csp: Planar YV12)
VDec: using Planar YV12 as output csp (no 0)
Movie-Aspect is undefined - no prescaling applied.
VO: [xv] 720x576 => 720x576 Planar YV12  [fs]
Selected video codec: [rawyv12] vfm:raw (RAW YV12)
==========================================================================
Audio: no sound
Starting playback...
v4l2: 730 frames successfully processed, 0 frames dropped.

kernel kartu detekuje ako:

lspci -v
00:06.0 Multimedia controller: Philips Semiconductors SAA7133 Video Broadcast Decoder (rev d0)
        Subsystem: Pinnacle Systems Inc.: Unknown device 002e
        Flags: bus master, medium devsel, latency 32, IRQ 10
        Memory at dfffb800 (32-bit, non-prefetchable) [size=2K]
        Capabilities: [40] Power Management version 2

modprobe -v saa7134 card=77 i2c_scan=1
dmesg
kobject_register failed for v4l1_compat (-17)
 [<c024d279>] kobject_register+0x49/0x70
 [<c01322b0>] mod_sysfs_setup+0x50/0xc0
 [<c013345e>] load_module+0x7ae/0xaa0
 [<c01337f2>] sys_init_module+0x72/0x200
 [<c01031c1>] syscall_call+0x7/0xb
saa7130/34: v4l2 driver version 0.2.14 loaded
saa7130/34: snapshot date 2005-11-18
ACPI: PCI Interrupt 0000:00:06.0[A] -> Link [LNKB] -> GSI 10 (level, low) -> IRQ 10
saa7133[0]: found at 0000:00:06.0, rev: 208, irq: 10, latency: 32, mmio: 0xdfffb800
saa7133[0]: subsystem: 11bd:002e, board: Pinnacle PCTV 110i (saa7133) [card=77,insmod option]
saa7133[0]: board init: gpio is 200e000
saa7133[0]: i2c eeprom 00: bd 11 2e 00 54 20 1c 00 43 43 a9 1c 55 d2 b2 92
saa7133[0]: i2c eeprom 10: ff e0 60 02 ff 20 ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 20: 01 2c 01 02 02 01 04 30 98 ff 00 a0 ff 22 00 c2
saa7133[0]: i2c eeprom 30: 96 ff 03 30 15 01 ff ff 0c 22 17 87 03 40 17 8a
saa7133[0]: i2c eeprom 40: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 50: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 60: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c eeprom 70: ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff ff
saa7133[0]: i2c scan: found device @ 0x8e  [???]
saa7133[0]: i2c scan: found device @ 0x96  [???]
saa7133[0]: i2c scan: found device @ 0xa0  [eeprom]
tuner 1-004b: chip found @ 0x96 (saa7133[0])
tuner 1-004b: setting tuner address to 61
tuner 1-004b: tuner: type set to tda8290+75a
saa7133[0]: registered device video0 [v4l2]
saa7133[0]: registered device vbi0
saa7133[0]: registered device radio0

je tam pisana karta 110i ale na linuxtv.org pisu, ze je to to iste ako 50i

kernel mam 2.6.14.2
system slackware 10.2

vopred diky za kazdu radu