Administrace komentářů

 ifdown wlan0
    wlan0     device: Broadcom Corporation BCM4318 [AirForce One 54g] 802.11g Wireless LAN Controller (rev 02)
    wlan0     configuration: wlan-wlan0
SuSEfirewall2: Warning: ip6tables does not support state matching. Extended IPv6 support disabled.
SuSEfirewall2: Setting up rules from /etc/sysconfig/SuSEfirewall2 ...
SuSEfirewall2: batch committing...
SuSEfirewall2: Firewall rules successfully set


 iwconfig

wlan0     IEEE 802.11b  ESSID:"tully"  Nickname:"tulyNX6125"
          Mode:Managed  Frequency:2.417 GHz  Access Point: 00:E0:98:C5:AE:44
          Bit Rate=11 Mb/s   Tx-Power:25 dBm
          RTS thr:off   Fragment thr:off
          Encryption key:7475-6C6C-79   Security mode:restricted
          Power Management:off
          Link Quality:100/100  Signal level:-50 dBm  Noise level:-256 dBm
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:61491   Missed beacon:0

rmmod -f ndiswrapper
tulyNX6125:/home/towdie # iwconfig
lo        no wireless extensions.

eth0      no wireless extensions.

wlan0     IEEE 802.11g  ESSID:off/any
          Mode:Managed  Frequency:2.462 GHz  Access Point: 00:00:00:00:00:00
          Bit Rate=54 Mb/s   Tx-Power:25 dBm
          RTS thr:off   Fragment thr:off
          Encryption key:off
          Power Management:off
          Link Quality:0  Signal level:0  Noise level:0
          Rx invalid nwid:0  Rx invalid crypt:0  Rx invalid frag:0
          Tx excessive retries:0  Invalid misc:0   Missed beacon:0