Administrace komentářů

Díky za reakci.... pochopil jsi to správě, ovšem problém je v tom, že je zde defaultne nastaveno, že se karta spouší v modu managed a dá se to změnit pomocí tohoto zápisu -

modprobe ath_pci autocreate=[none|sta|ap|wds|adhoc|ahdemo|monitor]

když ho zkusím použít tak mi to nevypíše žádnou chybu a po resetu je však vše jako předtím. Původí myšlenka právě byla, že kartu budu spouštět s tím parametrem NONE a poté ji nastavím do režimu AP v souboru /etc/network/interfaces. Alespoň to tak i píšou na stránkách s ovladači. Pro upřesění přikládám i skript, který by měl být v /etc/network/interfaces:

# Bring up ath0 with the correct wifi settings
# "manual" causes it to bring up the interface without TCP/IP (which will be setup on the bridge interface br0)
auto ath0
iface ath0 inet manual
    # set up the ath0 device in AP mode before bringing up the interface (unless you're using AutoCreate)
    # I had to add the following line for this config to work because udev creates the interface earlier 
    # in the init process.
    pre-up wlanconfig ath0 destroy 
    pre-up wlanconfig ath0 create wlandev wifi0 wlanmode ap
    # remove the ath0 device when bringing the interface down
    post-down wlanconfig ath0 destroy
    # set master mode, channel, and the essid
    wireless-mode master
    wireless-channel 11
    wireless-essid YourESSID
    # IF you use WEP, put the key here:
    #wireless-key 1234-1234-1234-1234

# Bring up the bridge device, br0
# Using DHCP to assign an IP, etc. may work as well,
#  but this illustrates setting up a static IP for the interface.
# The IP will be accessible from both the wired and wireless sides of the network.
auto br0
iface br0 inet static
    # Assign your IP address, subnet and mask, broadcast address, and default gateway
    address 192.168.0.[x]
    network 192.168.0.0
    netmask 255.255.255.0
    broadcast 192.168.0.255
    gateway 192.168.0.1
    # Bridge eth0 and ath0 with br0.
    bridge_ports eth0 ath0

# You do *not* need a separate entry for eth0 in this file, because you are not configuring it
# or bringing it up as a separate interface at all.  Mentioning it in the bridge_ports directive
# is enough.