Administrace komentářů

Ahoj, tuhle usb telku mam taky a netreba kompilit nic (mam kubuntu), jedine musim prihodit firmware, ktery je hledan.

Udelal jsem si soukr zapisek (cimz chci rict, ze nevim odkud to mam atd...) a tam stoji:

Soubor firmware zkopiruj do adresare /lib/firmware/{uname-a}/

FirmWare file je potreba prejmenovat na dvb-usb-dib0700-01.fw !!
Tohle je jmeno, ktere driver hleda v tomto adresari!

Fakt uz nevim proc se hleda prave toto jmeno a je klidne mozne, ze se u tebe bude hledat jine jmeno, neb mas treba jinou revizi toho usb cudliku, ale jako navod by ti to stacit mohlo... Cas od casu se pidim po novem driveru dle masky dvb-usb-07.* a staci mi opet jen to prejmenovat na to "spravne" jmeno a vse opet drandi.

Dmesg pak rika toto:

[362224.252000] dvb-usb: Leadtek Winfast DTV Dongle (STK7700P based) successfully deinitialized and disconnected.
[362236.448000] usb 4-1: new high speed USB device using ehci_hcd and address 11
[362237.208000] usb 1-1: new full speed USB device using uhci_hcd and address 2
[362237.348000] usb 1-1: not running at top speed; connect to a high speed hub
[362237.376000] usb 1-1: configuration #1 chosen from 1 choice
[362237.384000] dvb-usb: found a 'Leadtek Winfast DTV Dongle (STK7700P based)' in cold state, will try to load a firmware
[362237.412000] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-01.fw'
[362239.044000] dib0700: firmware started successfully.
[362239.548000] dvb-usb: found a 'Leadtek Winfast DTV Dongle (STK7700P based)' in warm state.
[362239.548000] dvb-usb: This USB2.0 device cannot be run on a USB1.1 port. (it lacks a hardware PID filter)
[362239.548000] dvb-usb: Leadtek Winfast DTV Dongle (STK7700P based) error while loading driver (-19)
[362252.376000] usb 1-1: USB disconnect, address 2
[362258.824000] usb 4-1: new high speed USB device using ehci_hcd and address 12
[362258.956000] usb 4-1: configuration #1 chosen from 1 choice
[362258.956000] dvb-usb: found a 'Leadtek Winfast DTV Dongle (STK7700P based)' in cold state, will try to load a firmware
[362259.004000] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-01.fw'
[362259.204000] dib0700: firmware started successfully.
[362259.708000] dvb-usb: found a 'Leadtek Winfast DTV Dongle (STK7700P based)' in warm state.
[362259.708000] dvb-usb: will pass the complete MPEG2 transport stream to the software demuxer.
[362259.708000] DVB: registering new adapter (Leadtek Winfast DTV Dongle (STK7700P based)).
[362259.980000] DVB: registering frontend 0 (DiBcom 7000MA/MB/PA/PB/MC)...
[362259.984000] MT2060: successfully identified (IF1 = 1220)
[362260.460000] dvb-usb: Leadtek Winfast DTV Dongle (STK7700P based) successfully initialized and connected.