Administrace komentářů

# dmesg | grep eth
Driver 'sd' needs updating - please use bus_type methods
eth0: (PCI Express:2.5GB/s:Width x4) 00:15:17:6f:a1:b4
eth0: Intel(R) PRO/1000 Network Connection
eth0: MAC: 0, PHY: 4, PBA No: d50868-003
eth1: (PCI Express:2.5GB/s:Width x4) 00:15:17:6f:a1:b5
eth1: Intel(R) PRO/1000 Network Connection
eth1: MAC: 0, PHY: 4, PBA No: d50868-003
eth2: RTL8168b/8111b at 0xffffc20000032000, 00:1e:8c:1e:e4:19, XID 38000000 IRQ 316
udev: renamed network interface eth2 to eth0
udev: renamed network interface eth0_rename to eth2
bonding: bond0: enslaving eth1 as an active interface with a down link.
bonding: bond0: enslaving eth2 as an active interface with a down link.
eth2: Link is Up 1000 Mbps Full Duplex, Flow Control: RX/TX
bonding: bond0: link status definitely up for interface eth2.
r8169: eth0: link up

#lspci | grep net
04:00.0 Ethernet controller: Realtek Semiconductor Co., Ltd. RTL8111/8168B PCI Express Gigabit Ethernet controller (rev 01)
05:00.0 Ethernet controller: Intel Corporation 82571EB Gigabit Ethernet Controller (rev 06)
05:00.1 Ethernet controller: Intel Corporation 82571EB Gigabit Ethernet Controller (rev 06)

#lsmod  (skratene)
r8169                  31172  0
e1000e                 95908  0

#cat /etc/network/interfaces (skratene)
auto eth0
iface eth0 inet dhcp

auto bond0
iface bond0 inet static
        address 192.168.1.200
        netmask 255.255.255.0
        hwaddress ether 00:15:17:6f:a1:b5
        up ifenslave bond0 eth1 eth2
        down ifenslave -d bond0 eth1 eth2

#ethtool eth0
Settings for eth0:
        Supported ports: [ TP ]
        Supported link modes:   10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Supports auto-negotiation: Yes
        Advertised link modes:  10baseT/Half 10baseT/Full
                                100baseT/Half 100baseT/Full
                                1000baseT/Full
        Advertised pause frame use: Symmetric Receive-only
        Advertised auto-negotiation: Yes
        Link partner advertised link modes:  Not reported
        Link partner advertised pause frame use: No
        Link partner advertised auto-negotiation: No
        Speed: 100Mb/s
        Duplex: Full
        Port: Twisted Pair
        PHYAD: 0
        Transceiver: internal
        Auto-negotiation: on
        Supports Wake-on: pumbg
        Wake-on: g
        Current message level: 0x00000033 (51)
        Link detected: yes

# ifconfig eth0
eth0      Link encap:Ethernet  HWaddr 00:1e:8c:1e:e4:19
          BROADCAST MULTICAST  MTU:1500  Metric:1
          RX packets:0 errors:0 dropped:0 overruns:0 frame:0
          TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
          collisions:0 txqueuelen:1000
          RX bytes:0 (0.0 B)  TX bytes:0 (0.0 B)
          Interrupt:60