Administrace komentářů

-l TYPE
              Reports increases in the number of errors in one of three SMART logs.  The valid arguments to this Directive are:

              error - [ATA] report if the number of ATA errors reported in the Summary SMART error log has increased since the last check.

              error  -  [NVMe]  [FreeBSD,  Linux,  Windows and Cygwin only] [NEW EXPERIMENTAL SMARTD FEATURE] report if the "Number of Error Information Log
              Entries" from the SMART/Health Information log has increased since the last check.

              xerror - [ATA] report if the number of ATA errors reported in the Extended Comprehensive SMART error log has increased since the last check.

              If both '-l error' and '-l xerror' are specified, smartd checks the maximum of both values.

              [Please see the smartctl -l xerror command-line option.]

              xerror - [NVMe] [FreeBSD, Linux, Windows and Cygwin only] [NEW EXPERIMENTAL SMARTD FEATURE] same as ´-l error´.

              selftest - report if the number of failed tests reported in the SMART Self-Test Log has increased since the last check, or  if  the  timestamp
              associated  with  the most recent failed test has increased.  Note that such errors will only be logged if you run self-tests on the disk (and
              it fails a test!).  Self-Tests can be run automatically by smartd: please see the '-s' Directive below.  Self-Tests can also be  run  manually
              by using the '-t short' and '-t long' options of smartctl and the results of the testing can be observed using the smartctl '-l selftest' com‐
              mand-line option.  [Please see the smartctl -l and -t command-line options.]

              [ATA only] Failed self-tests outdated by a newer successful extended self-test are ignored.  The warning email counter is reset if the  number
              of failed self tests dropped to 0.  This typically happens when an extended self-test is run after all bad sectors have been reallocated.

              offlinests[,ns]  -  [ATA  only]  report  if the Offline Data Collection status has changed since the last check.  The report will be logged as
              LOG_CRIT if the new status indicates an error.  With some drives the status often changes, therefore '-l offlinests' is not  enabled  by  '-a'
              Directive.  Appending ',ns' (no standby) to this directive is not implemented on Linux.

              selfteststs[,ns]  -  [ATA  only]  report  if  the  Self-Test  execution status has changed since the last check.  The report will be logged as
              LOG_CRIT if the new status indicates an error.  Appending ',ns' (no standby) to this directive is not implemented on Linux.

              scterc,READTIME,WRITETIME - [ATA only] sets the SCT Error Recovery Control settings to the specified values (deciseconds) when  smartd  starts
              up  and  has  no  further effect.  Values of 0 disable the feature, other values less than 65 are probably not supported.  For RAID configura‐
              tions, this is typically set to 70,70 deciseconds.  [Please see the smartctl -l scterc command-line option.]

smartd --debug