Administrace komentářů

Dík za tip, ale zdá sa, že to nefunguje. Najprv som vyskúšal tú trojicu príkazov bez úpravy konfiguráku.
Tu je výstup.

Potom som vyskúšal to isté po úprave konfiguráku a reštarte R-Pi (logovanie + huawei alt mode). Výstup je však rovnaký. A vznikol log, ktorého celý obsah prikladám nižšie. Zdá sa, systém ten modem prepína do "Mass storage mode" by default a je s tým ešte spokojný, ako dobre to prepol.

USB_ModeSwitch log from Fri Mar 12 20:20:03 CET 2021
Use global config file: /etc/usb_modeswitch.conf
Raw parameters: {--switch-mode} {1-1.2:1.0}
Use top device dir /sys/bus/usb/devices/1-1.2
Check class of first interface ...
Interface 0 class is 08.
----------------
USB values from sysfs:   manufacturer	Vodafone (Huawei)
product	K5150
serial	FFFFFFFFFFFFFFFF
----------------
Found packed config collection /usr/share/usb_modeswitch/configPack.tar.gz
ConfigList: /usr/share/usb_modeswitch/12d1:1f16 pack/12d1:1f16 pack/ 
SCSI attributes not needed, move on 
Check config: /usr/share/usb_modeswitch/12d1:1f16 ! matched.
Read config data Alternative Huawei mode set globally, modify config Device may have an MBIM configuration, check driver ...
driver for MBIM devices is available Find MBIM configuration number ...
Command line: usb_modeswitch -W -D  -b 1 -g 3 -v 12d1 -p 1f16 -f $flags(config)
Verbose debug output of usb_modeswitch and libusb follows (Note that some USB errors are to be expected in the process)
--------------------------------
Read long config from command line
* usb_modeswitch: handle USB devices with multiple modes
* Version 2.5.2 (C) Josua Dietze 2017
* Based on libusb1/libusbx   
! PLEASE REPORT NEW CONFIGURATIONS !
DefaultVendor=  0x12d1 DefaultProduct= 0x1f16 Configuration=0x02
System integration mode enabled
Use given bus/device number: 001/003 ...
Look for default devices ...
bus/device number matched
found USB ID 12d1:1f16
vendor ID matched
product ID matched
Found devices in default mode (1)
Get the current device configuration ...
Current configuration number is 1
Use interface number 0  with class 8
USB description data (for identification)
-------------------------
Manufacturer: Vodafone (Huawei)      
Product: K5150   
Serial No.: FFFFFFFFFFFFFFFF 
------------------------- 
Change configuration to 2 ... 
Looking for active drivers ...  
OK, driver detached  
OK, configuration set 
Get the current device configuration ... 
The configuration was set successfully ok:busdev 
-------------------------------- 
(end of usb_modeswitch output)  
Check success of mode switch for max. 20 seconds ...  
Read attributes ...  
All attributes matched Mode switching was successful, 
found 12d1:1f16 (Vodafone (Huawei): K5150) 
Logger is /usr/bin/logger 
Check for AVOID_RESET_QUIRK kernel attribute  AVOID_RESET_QUIRK activated  
All done, exit