Administrace komentářů

Zdravim. Na notebook Asus A6R-B002 som sa rozhodol nainstalovat Gentoo Linux. Vsetko islo v pohode, mam nahodene KDE a potrebny softver. Problem nastal az potom co som sa rozhodol k notebooku pripojit usb zariadenie (mys, usb disk..).

Vypis dmesg:

usb 2-1: new low speed USB device using ohci_hcd and address 2 ohci_hcd 0000:00:13.0: Unlink after no-IRQ? Controller is probably using the wrong IRQ.

Vypis /proc/interrupts:

201: 100000 IO-APIC-level ehci_hcd:usb1, ohci_hcd:usb2, ohci_hcd:usb3

Vypis lspci -v:

00:13.0 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller (prog -if 10 [OHCI]) Subsystem: ASUSTeK Computer Inc. Unknown device 1187 Flags: bus master, 66MHz, medium devsel, latency 64, IRQ 201 Memory at febff000 (32-bit, non-prefetchable) [size=4K] Capabilities: [d0] Message Signalled Interrupts: 64bit- Queue=0/0 Enable -

00:13.1 USB Controller: ATI Technologies Inc IXP SB400 USB Host Controller (prog -if 10 [OHCI]) Subsystem: ASUSTeK Computer Inc. Unknown device 1187 Flags: bus master, 66MHz, medium devsel, latency 64, IRQ 201 Memory at febfe000 (32-bit, non-prefetchable) [size=4K] Capabilities: [d0] Message Signalled Interrupts: 64bit- Queue=0/0 Enable

00:13.2 USB Controller: ATI Technologies Inc IXP SB400 USB2 Host Controller (pro g-if 20 [EHCI]) Subsystem: ASUSTeK Computer Inc. Unknown device 1187 Flags: bus master, 66MHz, medium devsel, latency 64, IRQ 201 Memory at febfd000 (32-bit, non-prefetchable) [size=4K] Capabilities: [dc] Power Management version 2 Capabilities: [d0] Message Signalled Interrupts: 64bit- Queue=0/0 Enable

Skusal som uz rozne kernely gentoo-sources(2.6.15-r1 az r7), ck-sources(2.6.15_p5), mm-sources(2.6.16_rc5-r10),nitro-sources(2.6.15-r3), rozne boot parametre pre kernel (irqpoll ,pci=routeirq, pci=biosirq,...etc), ale bezvysledne.Vopred vam dakujem za snahu pomoct mi, budem rad ked mi aspon jeden z prispevkov pomoze vyriesit tento na prvy pohlad banalny problem.