Administrace komentářů

Koupil jsem si MP3 prehravac TEAC MP-450 2GB, dle navodu by mel byt v linuxu bezproblemovy, jenze ja ho pripojim k USB, mam nastavene automaticke mountovani Flash do jedne slozky, MP3 to najde a otevre mi to slozku s tou MP3, jenze nenamountovalo mi to do te spravne slozky, ktera je nastavena v fstab tam mam dane ze vsechna zarizeni v sda1 se mountuji automaticky, kdyz pripojim fotak tak ten jde bez problemu, Ve slozce ktera se mi otevrela jsou soubory co jsou na MP3, tak dam nektery z tech souboru kopirovat a linux mi hodi hlasku "Neni mozne cist soubor /media/sda/soubor" a MP3 se odpoji. Kdyz ho pripojim ve Windowsu tak mi jde vsechno bez problemu, muzu kopirovat mazat vse, a kdyz v linuxu se pokusim nakopirovat nejaky soubor na ten MP3 tak ho to tam vlozi ale po odpojeni ten soubor v MP3 neni.vypis z dmesg

VFS: busy inodes on changed media.
VFS: busy inodes on changed media.
usb 1-5: new high speed USB device using ehci_hcd and address 7
usb 1-5: configuration #1 chosen from 1 choice
scsi9 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 7
usb-storage: waiting for device to settle before scanning
  Vendor: RockChip  Model: USB MP3           Rev: 1.00
  Type:   Direct-Access                      ANSI SCSI revision: 00
SCSI device sda: 4071424 512-byte hdwr sectors (2085 MB)
sda: Write Protect is off
sda: Mode Sense: 00 06 00 00
sda: assuming drive cache: write through
SCSI device sda: 4071424 512-byte hdwr sectors (2085 MB)
sda: Write Protect is off
sda: Mode Sense: 00 06 00 00
sda: assuming drive cache: write through
 sda: unknown partition table
sd 9:0:0:0: Attached scsi removable disk sda
usb-storage: device scan complete
usb 1-5: reset high speed USB device using ehci_hcd and address 7
usb 1-5: reset high speed USB device using ehci_hcd and address 7
usb 1-5: reset high speed USB device using ehci_hcd and address 7
ohci_hcd 0000:00:02.0: wakeup
sd 9:0:0:0: SCSI error: return code = 0x00070000
end_request: I/O error, dev sda, sector 3678816
sd 9:0:0:0: SCSI error: return code = 0x00070000
end_request: I/O error, dev sda, sector 3678816
usb 1-5: USB disconnect, address 7
usb 1-5: new high speed USB device using ehci_hcd and address 8
usb 1-5: configuration #1 chosen from 1 choice
scsi10 : SCSI emulation for USB Mass Storage devices
usb-storage: device found at 8
usb-storage: waiting for device to settle before scanning
  Vendor: RockChip  Model: USB MP3           Rev: 1.00
  Type:   Direct-Access                      ANSI SCSI revision: 00
SCSI device sda: 4071424 512-byte hdwr sectors (2085 MB)
sda: Write Protect is off
sda: Mode Sense: 00 06 00 00
sda: assuming drive cache: write through
SCSI device sda: 4071424 512-byte hdwr sectors (2085 MB)
sda: Write Protect is off
sda: Mode Sense: 00 06 00 00
sda: assuming drive cache: write through
 sda: unknown partition table
sd 10:0:0:0: Attached scsi removable disk sda
usb-storage: device scan complete