Administrace komentářů

Inspecting /boot/System.map-2.6.16.21-0.8-smp
Loaded 22659 symbols from /boot/System.map-2.6.16.21-0.8-smp.
Symbols match kernel version 2.6.16.
No module symbols loaded - kernel modules not enabled.

klogd 1.4.1, log source = ksyslog started.
<4>Bootdata ok (command line is root=/dev/system/root_lv vga=0x317    use_edd=1 resume=/dev/sda5  splash=silent)
<5>Linux version 2.6.16.21-0.8-smp (geeko@buildhost) (gcc version 4.1.0 (SUSE Linux)) #1 SMP Mon Jul 3 18:25:39 UTC 2006
<6>BIOS-provided physical RAM map:
<4> BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
<4> BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
<4> BIOS-e820: 0000000000100000 - 000000003fe7cc00 (usable)
<4> BIOS-e820: 000000003fe7cc00 - 000000003fe7ec00 (ACPI NVS)
<4> BIOS-e820: 000000003fe7ec00 - 000000003fe80c00 (ACPI data)
<4> BIOS-e820: 000000003fe80c00 - 0000000040000000 (reserved)
<4> BIOS-e820: 00000000f0000000 - 00000000f4000000 (reserved)
<4> BIOS-e820: 00000000fec00000 - 00000000fed00400 (reserved)
<4> BIOS-e820: 00000000fed20000 - 00000000feda0000 (reserved)
<4> BIOS-e820: 00000000fee00000 - 00000000fef00000 (reserved)
<4> BIOS-e820: 00000000ffb00000 - 0000000100000000 (reserved)
<7>ACPI: RSDP (v002 DELL                                  ) @ 0x00000000000febf0
<7>ACPI: XSDT (v001 DELL    B8K     0x00000014 ASL  0x00000061) @ 0x00000000000fd1fa
<7>ACPI: FADT (v003 DELL    B8K     0x00000014 ASL  0x00000061) @ 0x00000000000fd312
<7>ACPI: SSDT (v001   DELL    st_ex 0x00001000 INTL 0x20050624) @ 0x00000000fffd2658
<7>ACPI: MADT (v001 DELL    B8K     0x00000014 ASL  0x00000061) @ 0x00000000000fd406
<7>ACPI: BOOT (v001 DELL    B8K     0x00000014 ASL  0x00000061) @ 0x00000000000fd498
<7>ACPI: ASF! (v016 DELL    B8K     0x00000014 ASL  0x00000061) @ 0x00000000000fd4c0
<7>ACPI: MCFG (v001 DELL    B8K     0x00000014 ASL  0x00000061) @ 0x00000000000fd527
<7>ACPI: HPET (v001 DELL    B8K     0x00000014 ASL  0x00000061) @ 0x00000000000fd565
<7>ACPI: DSDT (v001   DELL    dt_ex 0x00001000 INTL 0x20050624) @ 0x0000000000000000
<6>No NUMA configuration found
<6>Faking a node at 0000000000000000-000000003fe7c000
<6>Bootmem setup node 0 0000000000000000-000000003fe7c000
<7>On node 0 totalpages: 257153
<7>  DMA zone: 3015 pages, LIFO batch:0
<7>  DMA32 zone: 254138 pages, LIFO batch:31
<7>  Normal zone: 0 pages, LIFO batch:0
<7>  HighMem zone: 0 pages, LIFO batch:0
<6>ACPI: PM-Timer IO Port: 0x808
<7>ACPI: Local APIC address 0xfee00000
<6>ACPI: LAPIC (acpi_id[0x01] lapic_id[0x00] enabled)
<6>Processor #0 6:15 APIC version 20
<6>ACPI: LAPIC (acpi_id[0x02] lapic_id[0x01] enabled)
<6>Processor #1 6:15 APIC version 20
<6>ACPI: LAPIC (acpi_id[0x03] lapic_id[0x05] disabled)
<6>ACPI: LAPIC (acpi_id[0x04] lapic_id[0x07] disabled)
<6>ACPI: LAPIC (acpi_id[0x05] lapic_id[0x00] disabled)
<6>ACPI: LAPIC (acpi_id[0x06] lapic_id[0x01] disabled)
<6>ACPI: LAPIC (acpi_id[0x07] lapic_id[0x02] disabled)
<6>ACPI: LAPIC (acpi_id[0x08] lapic_id[0x03] disabled)
<6>ACPI: LAPIC_NMI (acpi_id[0xff] high level lint[0x1])
<6>ACPI: IOAPIC (id[0x08] address[0xfec00000] gsi_base[0])
<6>IOAPIC[0]: apic_id 8, version 32, address 0xfec00000, GSI 0-23
<6>ACPI: INT_SRC_OVR (bus 0 bus_irq 0 global_irq 2 dfl dfl)
<6>ACPI: INT_SRC_OVR (bus 0 bus_irq 9 global_irq 9 high level)
<7>ACPI: IRQ0 used by override.
<7>ACPI: IRQ2 used by override.
<7>ACPI: IRQ9 used by override.
<6>Setting APIC routing to physical flat
<6>ACPI: HPET id: 0x8086a201 base: 0xfed00000
<6>Using ACPI (MADT) for SMP configuration information
<6>Allocating PCI resources starting at 50000000 (gap: 40000000:b0000000)
<4>Checking aperture...
<6>SMP: Allowing 8 CPUs, 6 hotplug CPUs
<4>Built 1 zonelists
<5>Kernel command line: root=/dev/system/root_lv vga=0x317    use_edd=1 resume=/dev/sda5  splash=silent
<6>bootsplash: silent mode.
<4>Initializing CPU#0
<4>PID hash table entries: 4096 (order: 12, 131072 bytes)
<6>time.c: Using 14.318180 MHz WALL HPET GTOD HPET/TSC timer.
<6>time.c: Detected 1862.050 MHz processor.
<4>Console: colour dummy device 80x25
<4>Dentry cache hash table entries: 131072 (order: 8, 1048576 bytes)
<4>Inode-cache hash table entries: 65536 (order: 7, 524288 bytes)
<4>Memory: 1023348k/1047024k available (1876k kernel code, 23288k reserved, 868k data, 184k init)
<4>Calibrating delay using timer specific routine.. 3727.51 BogoMIPS (lpj=7455037)
<6>Security Framework v1.0.0 initialized
<4>Mount-cache hash table entries: 256
<6>CPU: L1 I cache: 32K, L1 D cache: 32K
<6>CPU: L2 cache: 2048K
<4>using mwait in idle threads.
<6>CPU: Physical Processor ID: 0
<6>CPU: Processor Core ID: 0
<6>CPU0: Thermal monitoring enabled (TM2)
<6>checking if image is initramfs... it is
<4>Freeing initrd memory: 3148k freed
<4> not found!
<6>activating NMI Watchdog ... done.
<6>Using local APIC timer interrupts.
<4>result 16625437
<6>Detected 16.625 MHz APIC timer.
<6>Booting processor 1/2 APIC 0x1
<4>Initializing CPU#1
<4>Calibrating delay using timer specific routine.. 3724.17 BogoMIPS (lpj=7448341)
<6>CPU: L1 I cache: 32K, L1 D cache: 32K
<6>CPU: L2 cache: 2048K
<6>CPU: Physical Processor ID: 0
<6>CPU: Processor Core ID: 1
<6>CPU1: Thermal monitoring enabled (TM2)
<4>Intel(R) Xeon(R) CPU            3040  @ 1.86GHz stepping 02
<6>Brought up 2 CPUs
<6>testing NMI watchdog ... OK.
<4>migration_cost=26
<6>DMI 2.3 present.
<6>NET: Registered protocol family 16
<6>ACPI: bus type pci registered
<6>PCI: Using configuration type 1
<3>PCI: BIOS Bug: MCFG area is not E820-reserved
<3>PCI: Not using MMCONFIG.
<6>ACPI: Subsystem revision 20060127
<6>ACPI: Interpreter enabled
<6>ACPI: Using IOAPIC for interrupt routing
<6>ACPI: PCI Root Bridge [PCI0] (0000:00)
<7>PCI: Probing PCI hardware (bus 00)
<6>ACPI: Assume root bridge [\_SB_.PCI0] bus is 0
<6>PCI: Ignoring BAR0-3 of IDE controller 0000:00:1f.1
<7>Boot video device is 0000:05:07.0
<6>PCI: Transparent bridge - 0000:00:1e.0