Belkin F5D7001 v5

Ovladač:	dodává výrobce
Adresa ovladače:	http://www.belkin.com/support/download/downloadd..

Identifikace pod Linuxem

Ethernet controller: Atheros Communications, Inc.: Unknown device 001a (rev 01)
Subsystem: Belkin: Unknown device 701d
Flags: bus master, fast Back2Back, medium devsel, latency 128, IRQ 11
Memory at 56000000 (32-bit, non-prefetchable)
Capabilities: [44] Power Management version 2

Postup zprovoznění pod Linuxem

Zprovozneni pro Fedora Core 2: Je nutne zprovoznit ovladace z Windows pomoci ndiswrapperu. Ovladace se ziskaji v exe souboru, ktery se da rozbalit prikazem unzip. Funkcni ndiswrapper zobrazi:

$ ndiswrapper -l
Installed drivers:
blkwgn driver installed, hardware present

Pote je potreba nahrat ifcfg-wlan0 do /etc/sysconfig/network-scripts. Priklad:

# Wireless NDIS Wrapper config
# for more info read /usr/share/doc/initscripts-*/sysconfig.txt
DEVICE=wlan0
BOOTPROTO=dhcp # change this to static to specify an IP addr
HWADDR=00:11:50:70:88:71
ONBOOT=no
TYPE=Wireless
# DHCP_HOSTNAME=
MODE=Managed
ESSID=Essid
CHANNEL=11 # or 9
# IPADDR=
# DOMAIN=
# NETMASK=
USERCTL=yes
# PEERDNS=yes # this lets DHCP define the DNS setup
# GATEWAY=
# GATEWAYDEV=wlan0 # this is for setting default route
IPV6INIT=no
RATE=54Mb/s # speed of connection (11Mb/s, Auto,...)
# KEY=key key ke # needed only when WEP is turned on on AP

Pak by mela stacit jen posloupnost prikazu ifconfig wlan0 up a dhclient wlan0.

Zprovozneni pro Fedora Core 5: Pouziti madwifi ovladacu: Do rc.local pak staci ulozit modprobe ath_pci. Prikaz iwconfig zobrazi kartu jako ath0.

Poznámka

Zprovozneni pomoci ndiswrapperu se jevilo znacne nestabilni. Zprovozneni pomoci madwifi ovladacu se jevi stabilni. Systemy, ktere nejsou striktni, co se licenci tyka, maji zpravidla madwifi ovladace jiz zakomponovany v sobe, takze karta funguje jiz po spusteni. S madwifi ovladaci nefunguji nativne LED.

Dokument vytvořil: |🇵🇸, 28.4.2011 20:46 | Zobrazeno: 810×