AData MyFlash USB 2.0 disk - RB1

Ovladač:

v jádře

Technické parametry

USB2.0, odolny proti zniceni, vyrobce oficialne podporuje linux od jadra 2.4

Identifikace pod Linuxem

hub.c: new USB device 00:1d.7-2, assigned address 2
hub.c: USB hub found
hub.c: 1 port detected
hub.c: new USB device 00:1d.7-2.1, assigned address 3
usb.c: USB device 3 (vend/prod 0x67b/0x2517) is not claimed by any active driver.
SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi0 : SCSI emulation for USB Mass Storage devices
  Vendor: USB 2.0   Model: Flash Disk        Rev: PROL
  Type:   Direct-Access                      ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 3
USB Mass Storage support registered.
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
SCSI device sda: 256000 512-byte hdwr sectors (131 MB)
sda: Write Protect is off
 sda: sda1 sda2 sda3 sda4

Postup zprovoznění pod Linuxem

klasicky jako mass storage device, ale pozor! mount -t vfat /dev/sda /mnt ---- NE /dev/sda1!!!

Poznámka

zapis pod USB2.0 okolo 5.5 MB/s, ma to modrou ledku pro identifikace zapisu, zabudovany to ma v sobe primo USB hub s jednim portem, ale nechapu proc

Dokument vytvořil: CIJOML, 13.7.2004 20:13 | Zobrazeno: 1290×