Dotaz: Prepojenie SE K750i z PC cez USB

[RadoR]

Dobry den, pouzivam Slackware 10.2, jadro 2.4.31 a chcel by som pripojit SonyEricsson K750i cez pribaleny USB. Neviem kde robim chybu, vedel by mi niekto poradit? hlasky:

dmesg: Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage scsi1 : SCSI emulation for USB Mass Storage devices Vendor: Sony Eri Model: Memory Stick Rev: 0000 Type: Direct-Access ANSI SCSI revision: 02 Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 SCSI device sda: 126912 512-byte hdwr sectors (65 MB) sda: Write Protect is off sda: sda1 WARNING: USB Mass Storage data integrity not assured USB Mass Storage device found at 2 USB Mass Storage support registered.

lsmod: Module Size Used by Not tainted snd-pcm-oss 36736 0 (unused) snd-mixer-oss 12376 1 [snd-pcm-oss] parport_pc 15044 1 (autoclean) lp 6404 0 (autoclean) parport 22824 1 (autoclean) [parport_pc lp] usb-storage 62432 0 (unused) acm 5472 0 (unused) uhci 24284 0 (unused) ehci-hcd 17516 0 (unused) usbcore 59148 1 [usb-storage acm uhci ehci-hcd] i810_rng 2528 0 (unused) snd-intel8x0 18304 3 snd-ac97-codec 58556 0 [snd-intel8x0] snd-pcm 54344 0 [snd-pcm-oss snd-intel8x0 snd-ac97-codec] snd-timer 13764 0 [snd-pcm] snd 32772 2 [snd-pcm-oss snd-mixer-oss snd-intel8x0 snd-ac97-codec snd-pcm snd-timer] soundcore 3396 4 [snd] snd-page-alloc 4712 0 [snd-mixer-oss snd-intel8x0 snd-pcm snd-timer snd] ohci1394 23888 0 (unused) ieee1394 41636 0 [ohci1394] eepro100 18836 1 mii 2272 0 [eepro100] fuse 25140 0 (unused) ide-scsi 9392 0 agpgart 45508 0 (unused) apm 9452 2

fdisk -l: Disk /dev/sda: 64 MB, 64978944 bytes 4 heads, 19 sectors/track, 1669 cylinders Units = cylinders of 76 * 512 = 38912 bytes

Device Boot Start End Blocks Id System /dev/sda1 * 1 1670 63436+ 1 FAT12

mount -t vfat /dev/sda /mnt/SonyEricsson/: mount: wrong fs type, bad option, bad superblock on /dev/sda, missing codepage or other error In some cases useful info is found in syslog - try dmesg | tail or so

skusal som aj sda1; msdos, umsdos; aj naformatovat MMC v tel. na W95 FAT32, ale nic nepomohlo, vedel by mi niekto pomoct :-S. dakujem R.

---

---

Odpovědi

[CIJOML]

Vyhod to -t vfat - treba to pouziva jiny fs.

[RadoR]

napise mi to: mount: you must specify the filesystem type

[CIJOML]

a mountujes to pod rootem? Jestli ne, tak to musis mit povoleny v /etc/fstab

[RadoR]

jj, pod beznym uzivatelom by mi to hlasilo: mount: only root can do that a nie chybne sektory, bloky...

[buml]

Ja to mam na Etchi 2.6 v fstab

/dev/sda1 /mnt/usb vfat user,rw 0 0

a jede v poho

[RadoR]

myslim, ze to nieje vo verzii jadra, ale skor nejakymi jeho nastaveniami...?

[DNA]

mountujete to spatne, musi tam byt sda1 - mount -t vfat /dev/sda1 /mnt/SonyEricsson/

[RadoR]

skusal som vid. posledny r. otazky

[DNA]

me to jelo hned bez formátování, nechal jsem tam původní filesystem

Device Boot      Start         End      Blocks   Id  System
/dev/sdb1   *           1         990       63340+   6  FAT16

je to sdb1, sda mám sata disk. V /etc/fstab mám tohle

/dev/sdb1       /media/sdc1     vfat    rw,user,defaults,noauto 0       0

a lsmod (divné je že mi funguje automount i když mám usb napevno v jádře):

Module                  Size  Used by
nls_iso8859_1           4224  1
nls_cp437               5888  1
nls_iso8859_2           4864  1
nvidia               4545108  12
binfmt_misc             8328  1
lirc_serial            10752  1
lirc_dev               11780  1 lirc_serial
ipv6                  203680  12
parport_pc             28324  0
parport                30664  1 parport_pc

lsusb:

Bus 005 Device 005: ID 0fce:d016 Sony Ericsson Mobile Communications AB
Bus 005 Device 001: ID 0000:0000
Bus 001 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000

[RadoR]

pre lepsiu citelnost este raz vypisem hlasky:

dmesg
hub.c: new USB device 00:1d.0-2, assigned address 2
usb.c: USB device 2 (vend/prod 0xfce/0xd016) is not claimed by any active driver.
usb.c: registered new driver acm
ttyACM0: USB ACM device
ttyACM1: USB ACM device
acm.c: v0.21:USB Abstract Control Model driver for USB modems and ISDN adapters
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi1 : SCSI emulation for USB Mass Storage devices
  Vendor: Sony Eri  Model: Memory Stick      Rev: 0000
  Type:   Direct-Access                      ANSI SCSI revision: 02
Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
SCSI device sda: 126912 512-byte hdwr sectors (65 MB)
sda: Write Protect is off
 sda: sda1
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.

fdisk(povodny format z mobilu)
Disk /dev/sda: 64 MB, 64978944 bytes
4 heads, 19 sectors/track, 1669 cylinders
Units = cylinders of 76 * 512 = 38912 bytes

   Device Boot      Start         End      Blocks   Id  System
/dev/sda1   *           1        1670       63436+   1  FAT12

lsusb
Bus 005 Device 001: ID 0000:0000
Bus 004 Device 001: ID 0000:0000
Bus 003 Device 001: ID 0000:0000
Bus 002 Device 001: ID 0000:0000
Bus 002 Device 002: ID 0fce:d016 Sony Ericsson Mobile Communications AB
Bus 001 Device 001: ID 0000:0000

[DNA]

všiml jsem si že máte fat12 a já fat16, ten telefon s tím nemá problémy? každopádně bych to zkusil přeformátovat na fat16

[RadoR]

ten format si voli sam telefon, s tym formatom som to kupil a aj ked som nechal kartu preformatovat telefonom, tak spravil fat 12 - telefon s tym problem nema...

[RadoR]

... a este

lsmod
Module                  Size  Used by    Not tainted
usb-storage            62432   0
acm                     5472   0  (unused)
snd-pcm-oss            36736   0  (unused)
snd-mixer-oss          12376   1  [snd-pcm-oss]
parport_pc             15044   1  (autoclean)
lp                      6404   0  (autoclean)
parport                22824   1  (autoclean) [parport_pc lp]
uhci                   24284   0  (unused)
ehci-hcd               17516   0  (unused)
usbcore                59148   1  [usb-storage acm uhci ehci-hcd]
i810_rng                2528   0  (unused)
snd-intel8x0           18304   3
snd-ac97-codec         58556   0  [snd-intel8x0]
snd-pcm                54344   0  [snd-pcm-oss snd-intel8x0 snd-ac97-codec]
snd-timer              13764   0  [snd-pcm]
snd                    32772   2  [snd-pcm-oss snd-mixer-oss snd-intel8x0 snd-ac97-codec snd-pcm snd-timer]
soundcore               3396   4  [snd]
snd-page-alloc          4712   0  [snd-mixer-oss snd-intel8x0 snd-pcm snd-timer snd]
ohci1394               23888   0  (unused)
ieee1394               41636   0  [ohci1394]
eepro100               18836   1
mii                     2272   0  [eepro100]
fuse                   25140   0  (unused)
ide-scsi                9392   0
agpgart                45508   0  (unused)
apm                     9452   2

[RadoR]

mimochodom ospravedlnujem sa za hrubku v titule - malo tam byt Prepojenie SE K750i s PC cez USB :-S

[RadoR]

Mam taky pocit, ze som prisiel na to co tomu chyba - nemam zavedeny modul scsi_mod - hm, ale ako na to?

[RadoR]

modul scsi_mod nemam pravdepodobne spristupneny v jadre systemu pretoze insmod mi napise: insmod: scsi_mod: no module by that name found, vedel by mi niekto poradit, ako to rozchodit, dakujem

[pep]

Zahledl jsem kdesi na netu tohle: /dev/sda1 on /media/usbdisk type vfat (rw,nosuid,nodev,quiet,shortname=mixed,uid=1000,gid=1000,umask=077,iocharset=utf8) treba to mpomuze

[RadoR]

no tak skusil som ale zial nepomohlo, do fstab som napisal:

/dev/sda1        /mnt/SonyEricsson vfat        rw,nosuid,nodev,quiet,shortname=mixed,uid=1000,gid=1000,umask=077,iocharset=utf8               0   0

a po smahe o mount mi opat vypisal:

mount: wrong fs type, bad option, bad superblock on /dev/sda1,
       missing codepage or other error
       In some cases useful info is found in syslog - try
       dmesg | tail  or so

[RadoR]

...ale aj tak dakujem za snahu o pomoc

[DNA]

fdisk napsal že ten telefon vidí, modulem to asi nebude...

[sweto]

co tak skusit odstranit particiu a vytvorit tam novu, trebars aj ext2 a skusit to primontovat. pokial by to fungovalo, tak skusit rovnaky postup s fat16

[RadoR]

no skutocne ono to funguje - bolo treba zformatovat kartu a rozbehlo sa to, nechal som tam FAT 12, ako bola originalne naformatovana, ale myslim, ze by to zvladlo aj FAT 16, takze dakujem velmi ste mi pomohli