Dotaz: Active-backup vyber rozhrania

[asdfg64]

Zdravim, mam problem s nahodenim active-backup konfiguracie. Pri boote sa vzdy stane eth1 aktivne a eth0 zostane backup. Skusal som v konfiguracii zamenit eth0 za eth1 avsak stale pride k vyberu eth1. Neviete poradit ako donutit aby sa stalo aktivne eth0?

# cat /proc/net/bonding/bond0
Ethernet Channel Bonding Driver: v3.7.1 (April 27, 2011)

Bonding Mode: fault-tolerance (active-backup)
Primary Slave: None
Currently Active Slave: eth1
MII Status: up
MII Polling Interval (ms): 100
Up Delay (ms): 200
Down Delay (ms): 200

Slave Interface: eth0
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:25:XX:XX:1e:86
Slave queue ID: 0

Slave Interface: eth1
MII Status: up
Speed: 1000 Mbps
Duplex: full
Link Failure Count: 0
Permanent HW addr: 00:25:XX:XX:1e:87
Slave queue ID: 0
root@localhost:~# cat /etc/network/interfaces
auto lo
iface lo inet loopback

auto bond0
iface bond0 inet static
        address X.X.X.X
        netmask X.X.X.X
        gateway X.X.X.X
        slaves eth0 eth1
        bond-mode active-backup
        bond-miimon 100
        bond-downdelay 200
        bond-updelay 200

Odpovědi

[Trpka]

primary je nutne dat jako parametr pri loadu modulu pro bond0, pro debian/ubuntu viz.

https://wiki.debian.org/NetworkConfiguration#bonding_with_active_backup