Administrace komentářů

dekuju. Me to v pohode vsechno provede podle toho navodu nez dojdu k $ ifconfig wlan0 up, $ iwlist wlan0 scan. Ale pak napise SIOCSIFFLAGS: Chyba vstupu/výstupu. a na tom zkoncim. Nestalo se to nekomu nebo nevedel by prosim vas nekdo jak na to? Predem diki za kazkou odpoved.

tady prikladam ten navod 1. Unpack the driver sources and go to the Module directory: $ tar -xvzf rt73-cvs-daily.tar.gz $ cd ./rt73-cvs-YYYYMMDDHH/Module

2. Compile the driver sources: $ make

3. Install the driver (as root): # make install

==================== INVOCATION ==================== Load the driver:

$ modprobe rt73 [ifname=name] [debug=mask] [firmName=file]

name is the name of the device and defaults to "wlan%d". If more than one adapter is installed, successive devices will be named wlan0, wlan1, etc. If you wish to use a different scheme - say eth*, and there are already wired ethernet devices named eth0 and eth1, then specifying name as "eth%d" gives the adapter the name "eth2".

mask is a decimal or hex number. See TESTING file. Ignored if driver compiled without debug support.

file is the name of a firmware file and defaults to "rt73.bin" if omitted. Only the basename - not the full path - may be specified.

Start it up:

$ ifup wlan0 # If using Debian - or $ ifconfig wlan0 up $ iwlist wlan0 scan

If everything is ok, you should see a list of surrounding Access Points. It means you can jump to the configuration section. Otherwise, check out the following install notes...